Dunlop Authentic Hendrix 68 Shrine Series User manual

This special edition of the Uni-Vibe Chorus/Vibrato
pays tribute to the legendary Jimi Hendrix with a
custom nish that remixes prolic and celebrated
rock artist John Van Hamserveld’s famous 1968
Shrine Auditorium concert poster art. Packed
into an MXR mini housing, this pedal delivers the
thick wash of tones and textures that permeate
the landmark Band of Gypsys album in all of their
stunning analog glory at a fraction of the size of
the vintage Shin-ei unit that Jimi Hendrix used
from 1969 to 1970.
JHMS3
jimdunlop.com/jhms3
Authentic Hendrix
‘68 Shrine Series
Uni-Vibe
Chorus/Vibrato
™
®

JHMS3 | AUTHENTIC HENDRIX™’68 SHRINE SERIES UNI-VIBE®CHORUS/VIBRATO 2
1SPEED knob controls sweep rate of effect
2LEVEL knob controls overall volume of effect
3VIBE switch toggles between chorus mode and vibrato mode
4DEPTH knob controls overall intensity of effect
5FOOTSWITCH toggles effect on/bypass (white LED indicates on)
External Controls
1 4
5
3
2

JHMS3 | AUTHENTIC HENDRIX™’68 SHRINE SERIES UNI-VIBE®CHORUS/VIBRATO 3
The Authentic Hendrix™’68 Shrine Series Uni-Vibe®
Chorus/Vibrato is powered by the Dunlop ECB003
9-volt adapter or an MXR®Brick™Series power supply
(each sold separately). This pedal cannot be powered
by a battery.
Power
1 Run a cable from your guitar to the JHMS3’s INPUT jack
and run another cable from the JHMS3’s OUTPUT jack
to your amplifier.
2 Start with SPEED, LEVEL, and DEPTH controls at 12
o’clock.
3 Turn the effect on by depressing the footswitch.
4 Rotate SPEED knob clockwise to increase sweep rate of
effect or counterclockwise to decrease it.
5 Rotate LEVEL knob clockwise to increase overall volume
or counterclockwise to decrease it.
6 Rotate the DEPTH knob clockwise to increase intensity
of effect or counterclockwise to decrease it.
7 With the VIBE switch in its OUT position, the pedal is set
to chorus mode. Push the VIBE switch IN to engage vibrato
mode, indicated by associated LED.
Directions
Basic Operation

JHMS3 | AUTHENTIC HENDRIX™’68 SHRINE SERIES UNI-VIBE®CHORUS/VIBRATO 4
Specifications
Input Impedance 730 kΩ
Output Impedance
Full Volume 180 kΩ
Half Volume 33 kΩ
Max Input 0 dBV
Max Output 27 dBV
Noise Floor* -97 dBV
Speed Control 0.5 Hz to 10.5 Hz
Bypass True Hardwire
Input Impedance 600 kΩ
Output Impedance
Full Volume 29 kΩ
Half Volume 33 kΩ
Max Input 0 dBV
Max Output 8 dBV
Noise Floor* -97 dBV
Speed Control 0.5 Hz to 10.5 Hz
Bypass True Hardwire
VIBE ON
VIBE OFF
Current Draw 5 mA
Power Requirements 9 volts DC
POWER REQUIREMENTS