Dunlop CRY BABY JUNIOR WAH User manual

CRY BABY®JUNIOR WAH
CBJ95

CBJ95 CRY BABY®JUNIOR WAH 2
1 VOICING switch selects one of three different frequency ranges
2 FOOTSWITCH toggles effect on/bypass (white LED indicates on)
EXTERNAL CONTROLS
2
1

CBJ95 CRY BABY®JUNIOR WAH 3
BASIC OPERATION
POWER
The Cry Baby®Junior Wah is powered by one 9-volt battery
(accessed via the bottom of the pedal), the Dunlop ECB003
9-volt adapter, or the DC Brick™ , Iso-Brick™ , and Mini Iso-Brick™
power supplies.
OPERATION
1. Run a shielded instrument cable from your guitar to the
CBJ95’s INSTRUMENT jack.
2. Run another shielded instrument cable from the CBJ95’s
AMPLIFIER jack into your amplifier input.
3. Turn on the amplifier and begin playing.
4. To turn the pedal on/off, push the top of the pedal down
until you hear a “Click”.
5. Located under the rocker at the heel of the pedal is an
adjustable torque clutch that allows the amount of resistance
the rocker has to being moved. Turn clockwise to increase
resistance or counterclockwise to decrease resistance (wrench
included). See TORQUE ADJUSTMENT diagram.
6. The VOICING switch allows you to change the frequency
range of the CBJ95. Default setting is H—High, for the
standard GCB95 sound. For a more vintage, midrange-focused
sound, set the switch to M. For a lower frequency range, select
L. See VOICING SWITCH diagram.
7. By rocking your foot back and forth on the mini pedal, you
can instantaneously change the effect that the Cry Baby Wah
has on the tone of your instrument.
TORQUE ADJUSTMENT
H 380 Hz to 2100 Hz
M 330 Hz to 1800 Hz
L 270 Hz to 1500 Hz
VOICING SWITCH
HML

CBJ95 CRY BABY®JUNIOR WAH 4
SPECIFICATIONS
Input Impedance 800 kΩ
Output Impedance <10 kΩ
*A-weighted
IMPEDANCE
Input -8.0 dBV
Output +10 dBV
Heel Down +19.5 dB
Toe Down +19.0 dB
Heel Down -98 dBV
Toe Down -89 dBV
MAXIMUM LEVEL
MAXIMUM GAIN
NOISE FLOOR*
Range Selector Switch Position (H towards Heel, L towards Toe)
H 380 Hz to 2100 Hz
M 330 Hz to 1800 Hz
L 270 Hz to 1500 Hz
WAH RANGE SELECTOR
Bypass True Hardwire
Current Draw 3 mA
Power Supply 9 volts DC