Dunlop EVH117 User manual

92503003509revA
MXR EVH Flanger
The EVH Flanger meets Edward Van Halen’s demanding specs and
requirements. Please take a minute to read through this manual so
you can get the most out of your EVH Flanger.
“It’s part of my sound and it’s on tons of our stuff. I’ve used it with a
guitar, (Unchaine, Hear about it later) electric piano, (And the Cradle
will Rock) synths ( Sunday afternoon in the park) It’s simple, powerful,
consistent, reliable and a very distinct sound. A true stomp box”.

POWER
The EVH Flanger is powered by two
9 volt batteries (accessed through
the bottom of the pedal), an 18 volt
AC adapter such as the Dunlop
ECB004/ECB004EU, or a DC
Brick™power supply.
DESCRIPTION
• Four different parameters
for precise ne-tuning
• EVH switch engages
“Unchained” anger tone
• Custom EVH paint job
DIRECTIONS
• Run a cable from your guitar to
the EVH Flanger’s INPUT jack
and run another cable from the
EVH Flanger’s OUTPUT jack to
your amplier.
• Start with all controls at 12
o’clock and the EVH switch
disengaged.
• Turn the effect on by depressing
the footswitch.
• Rotate the MANUAL control
clockwise to emphasize higher
frequencies or counterclockwise
to emphasize lower frequencies.
• Rotate the WIDTH control
clockwise to increase the
intensity of the time delay as
set by the SPEED control or
counterclockwise to decrease it.
SPECIFICATIONS
Input Impedance 470 kΩ
Output Impedance 1 kΩ
Signal to Noise* >98 dB
Noise Reduction 2:1 ratio
Max Delay 12.8 ms
Rate Range 0.1 Hz to 10 Hz
Bypass Hardwire
Current Draw 35 mA
Power Supply 9 volts DC
*A-weighted, 0 dB = 1 Vrms
• Rotate the SPEED knob
clockwise for a faster phase
effect or counterclockwise
for a slower phase effect.
• Rotate the REGEN. control
clockwise to increase the
overall intensity of the effect or
counterclockwise to decrease it.
• Pushing in the EVH switch
(indicated by yellow LED)
engages the EVH “Unchained”
mode, which overrides the
MANUAL, WIDTH, SPEED and
REGEN. controls with preset
values for classic EVH anging.
DUNLOP MANUFACTURING, INC.
P.O. BOX 846 BENICIA, CA 94510 U.S.A.
TEL: [phone] FAX: [phone]
CONTROLS
MANUAL knob controls
degree of phase shifting
WIDTH knob controls
intensity of time delay
set by SPEED knob
SPEED knob controls
speed of time delay
REGEN. knob controls
overall intensity of effect
EVH switch engages
“Unchained” mode
(indicated by yellow LED)
FOOTSWITCH toggles
effect on/bypass
(blue LED indicates on)
EVH117 FLANGER