Dunlop AKIRA TAKASAKI CRY BABY FUZZ WAH User manual

CRY BABY® AKIRA TAKASAKI FUZZ WAH
AT95M
®

AT95M CRY BABY®AKIRA TAKASAKI FUZZ WAH 2
1 FUZZ SENSITIVITY knob adjusts intensity of fuzz effect
2 FUZZ ON/OFF switch toggles fuzz effect on/off (green LED indicates ON)
EXTERNAL CONTROLS
2
1

AT95M CRY BABY®AKIRA TAKASAKI FUZZ WAH 3
INTERNAL CONTROLS
1 FUZZ VOLUME knob adjusts pedal volume when fuzz mode is engaged
2 BYPASS DELAY knob sets wah effect ring-out time after rocker returns to its heel position
1
2

AT95M CRY BABY®AKIRA TAKASAKI FUZZ WAH 4
BASIC OPERATION
POWER
The Cry Baby®Akira Takasaki Fuzz Wah is powered by one 9-volt
battery (accessed via underside of pedal), the Dunlop ECB003 9-volt
adapter, or an MXR®Brick™Series power supply.
OPERATION
1. Run a cable from your guitar to the AT95M’s INPUT jack and run
another cable from the AT95M’s OUTPUT jack to your amplifier.
2. Push the FUZZ ON/OFF switch IN to engage the fuzz effect,
indicated by rear green LED. To disengage fuzz mode, push the
switch again to its OUT position.
3. Rotate the FUZZ SENSITIVITY knob clockwise to increase fuzz
intensity or counterclockwise to decrease it.
4. To access the internal FUZZ VOLUME control, remove the bottom
plate. Rotate the internal FUZZ VOLUME knob clockwise to increase
overall volume when the fuzz mode is engaged or counterclockwise
to decrease it.
5. This pedal is bypassed (off) while your foot is off the rocker. To
engage the wah effect, simply press the toe of the pedal down with
your foot. Rear blue LED will illuminate when wah effect is engaged.
6. To increase rocker effect ring-out time, rotate external BYPASS
DELAY knob with center detent counterclockwise. To decrease effect
ring-out time, rotate the knob clockwise.

AT95M CRY BABY®AKIRA TAKASAKI FUZZ WAH 5
SPECIFICATIONS
* Measured at 1kHz
Heel Down 480 Hz
Toe Down 2.2 kHz
Current Draw 7 mA
Power Supply 9VDC
Bypass Buffered Bypass
RESONANT FREQUENCY
WAH FUZZ-WAH
Input 1.1 MΩ480 kΩ
Output 4.3 kΩ3.8 kΩ
IMPEDANCE*
Heel Down -98 dBu -72 dBu
Toe Down -91 dBu -60 dBu
Effect Off -105 dBu -105 dBu
Max Gain +22 dB +60 dB
Max Output Level +8.7 dBu +5.0 dBu
NOISE FLOOR