Dunlop JERRY CANTRELL CRY BABY User manual

JERRY CANTRELL CRY BABY®WAH
JC95B

JC95B JERRY CANTRELL CRY BABY®WAH 2
1 FINE TUNE knob adjusts tone of toe-down rocker position
EXTERNAL CONTROLS
1

JC95B JERRY CANTRELL CRY BABY®WAH 3
BASIC OPERATION
POWER
The Jerry Cantrell Cry Baby® Wah is powered by one 9-volt battery
(remove bottom plate to install), the Dunlop ECB003 9-volt adapter,
or the DC Brick™, Iso-Brick™, and Mini Iso-Brick™ power supplies.
OPERATION
1. Run an instrument cable from your guitar to the JC95B’s
INSTRUMENT jack and another instrument cable from the JC95B’s
AMPLIFIER jack into your amplifier’s input.
2. Push the toe of the pedal down until you feel a “click” to turn the
pedal on/off.
3. Rotate the FINE TUNE knob clockwise for a brighter toe-down
response or counterclockwise for a darker toe-down response.
4. Rock your foot back and forth on the pedal to hear the vocal,
expressive tones that the Cry Baby Wah is famous for.

JC95B JERRY CANTRELL CRY BABY®WAH 4
SPECIFICATIONS
Input Impedance 1MΩ
Output Impedance 10MΩ
* VREF=1VRMS, A-weighted
IMPEDANCE
Heel Down 320 Hz to 390 Hz
Toe Down Fine Tune Max 1700 Hz to 2070 Hz
Toe Down Fine Tune Min 1050 kHz to 1270 Hz
FILTER CENTER FREQUENCY
Input -11.5 dBV
Output +6 dBV
Heel Down +18 dBV
Toe Down +20 dBV
Heel Down >97 dB
Toe Down >89 dB
MAXIMUM LEVEL
MAXIMUM GAIN AT CENTER FREQUENCY
NOISE FLOOR*
Bypass Hardwire
Current Draw 1 mA
Power Supply DC 9 volts