Dunlop MC404 CAE WAH User manual

92503007900revE
MC404 CAE WAH

POWER
The MC404 CAE Wah is powered by
one 9-volt battery (accessed via bottom
of pedal), a 9-volt AC Adapter such as
the Dunlop ECB003/ECB003E or a
DC Brick™power supply.
SETUP INSTRUCTIONS
•Runashieldedinstrumentcablefrom
yourguitartotheMC404’sINSTRUMENT
jack and run another instrument cable from
theMC404’sAMPLIFIERjacktoyouramp.
•Toturnthepedalon/off,pushthetoeofthe
pedal down until you feel a “click.” Illumi-
nated green LED indicates “on.”
•ForaclassicCryBabysound,engagethe
yellow Fasel®inductor by pushing the
INDUCTORswitchtoits“in”position
(indicated by illuminated yellow LED).
•Foradeeperwahsoundwithincreased
fundamental, engage the red Fasel®inductor
bysettingtheINDUCTORswitchtoits“out”
position (indicated by illuminated red LED).
SPECIFICATIONS
Impedance
Input 1 MΩ
Output <10kΩ
Center Freq. (Yellow Inductor)
Heel Down 400 Hz
Toe Down 1.9 kHz to 2.2 kHz
Center Freq. (Red Inductor)
Heel Down 255 Hz to 355 Hz
Toe Down 1.3 kHz to 1.5 kHz
Maximum Level
Input -6 dBV
Output +8dBV
Maximum Gain
HeelDown +16dB
ToeDown +16dB
Noise Floor
HeelDown -85.5dBV
ToeDown -82.0dBV
Bypass True Bypass
Current Draw <6.3mA
MC404 CAE WAH
•Toboostyourwahsignal,pushinthe
BOOSTswitch(indicatedbyilluminated
blueLED)andusetheBOOSTVOLUME
knobtosetdesiredboostlevel(upto+20dB).
•UseinternalTRIMPOTStoadjusttheQof
each Fasel®inductor—rotate clockwise for
a narrower bandpass or counterclockwise
for a wider bandpass.
CONTROLS
1BOOSTVOLUMEknobcontrolsamount
ofgainaddedbyBOOSTswitch
2 UPPERTRIMPOTcontrolsQ
of yellow inductor
3 LOWERTRIMPOTcontrolsQ
of red inductor
4 INDUCTORswitchtogglesred/yellow
inductors
5BOOSTswitchengagesboostlevel
setbyBOOSTVOLUMEknob