Durabike eazi-rider City User manual

Page
12
e
azi
-
rider
-
City
e
azi
-
rider
-
City
Page
1
Operating Instructions

Page
2
e
azi
-
rider
-
City
e
azi
-
rider
-
City
Page
11
Registration
Your Durabike is guaranteed for 1 year.
Please fill in the following details and return to the address below.
Your Details
Name:
Address:
Contact Number:
E
-
mail:
Retailer Details
Name:
Branch Address:
Date of purchase
:
Receipt Number:
Bike Details
Model
Number: BKE301 eazi-rider City
Bailcast
P/L Ref:
Durabike Warranty Registration
Bailcast Limited,
Chorley North Industrial Park,
Chorley, Lancashire
PR6 7BX
Detach here

Page
10
e
azi
-
rider
-
City
e
azi
-
rider
-
City
Page
3
Contents
Page
o Contents 3
o Getting to Know Your Bike 4
o Introduction 5
o Technical Information 5
o Operation 6
o Folding the Bike 7
o Set-up and Adjustment 8
o Maintenance 9
o Manufacturer’s Warranty Card 11

Page
4
e
azi
-
rider
-
City
e
azi
-
rider
-
City
Page
9
Maintenance
Charger
The charger is a sealed unit. It should not be tampered with nor cables or plugs
changed.
It must be used in a safe well ventilated area, protected from heat and damp out of
reach of children and away from flammable or explosive materials.
Liquids or metal objects must not be put into the charger.
Charging
First connect the charger lead to the battery. Then plug into the wall socket and
switch on.
The LED on the charger will glow RED to show charging; It will show BLUE when
charging is complete.
Monitor the charger from time to time and promptly turn off when the blue light
shows.
Disconnect the battery first, then the wall socket.
Normal charging is 3-6 hours; never leave the charge on longer than 10 hours.
If the charger overheats or smells hot, stop charging.
Motor and Controller
Protect the exposed wiring to avoid damage which could result in a short circuit.
Avoid exposing the controller to damp while washing and do not immerse the
motor.
Important Information
Please complete the following as it will form part of your warranty:
Retailer Details
Name:
Purchase
Date:
Receipt Number:
Bike Details
Model: BKE301 eazi-rider City
Frame Number:
Motor Number:
Battery Number:

Page
8
e
azi
-
rider
-
City
Set-up and Adjustment
Pedals
Pedal are stamped (L)eft or (R)ight on the ends.
Install correctly, noting that the left hand has a left hand thread.
Chain Tension
The rear wheel will be set before delivery to give the correct tension. In the event
that the hub has moved it should be set by a person with experience of Deraileur
gears.
Wheels
Check that the tyre is central in the forks. Check tightness of hub nuts to these
figures.
Front wheel – minimum 18Nm; Rear wheel – minimum 30Nm
Head tube and Saddle Tube
Adjust for height. The maximum safe height is indicated by a safety line which
must not be exposed.
Quick release accessories
The locking force required is between 15-17kgf.
Lubrication
Chain and crank should be lubricated with spray lubricant.
The headset should be given a few drops of oil monthly.
Brakes
Inspect all brake blocks regularly and replace early. If metal parts come into
contact with the aluminium rim replacement will be needed.
Battery
The battery is a new generation Li-ion battery, amazingly powerful and light. For
best life, always charge the battery with the supplied charger which continuously
controls the charge rate according to temperature.
Charge the battery before first use; the performance will improve after a few
recharges.
With regular charging, the battery is good for better than 1,000 cycles.
Performance will be reduced by low temperature; as much as 30% will be lost at
temperatures below 0oc, which will be recovered on warming.
The battery should be part charged monthly, or the warranty will be invalidated.
(Even if it means going out in the cold and wet) Avoid dropping the battery and
protect it from impact. Keep the battery away from heat, direct sunlight and damp.
Protect the charging port with the rubber bung supplied to avoid ingress of
moisture or dirt.
As the battery contains flammable materials it must be taken to a recycling site for
correct disposal. Under no circumstances should the battery be put into a fire.
For charging guidelines see page 9.
e
azi
-
rider
-
City
Page
5
Introduction
Please spare a few minutes to become familiar with this manual.
It will help you to get the best from the excellent Durabike. Retain the manual in
case you wish to lend the bike or pass it on, or even need to refresh your memory
of some detail.
The Durabike is fine in rain or snow. It is not amphibious and immersion in water
would short out the motor and invalidate the warranty. Do not overload the
Durabike (max 90kg) and remember that a fully loaded bike will be less responsive
in braking or steering.
When the bike is not in use, always turn off the motor and remove the key.
To prevent serious damage to the motor and controller do not ride without the
battery in place, particularly downhill.
Technical Information
Dimensions
(LxWxH)
Open: 1550mm x 180mm (Handle bars) x 1030mm
Folded: 800mm x 300mm x 580mm
Wheel Size 20” Wheel Base 1045 mm
Frame Material Aluminium Alloy Net Weight 22 kg
Maximum Load 90 kg Maximum Speed 25 km/h
Motor
Type Mini high speed
brushless Specification 36V250W
Rated Speed 280r/min Output Torque 7.5N.m
Controller
Cut-off voltage 30±1V Burst Discharge
Current 13±1A
Charger
Input Voltage AC110-240V 0.8A
50-60Hz
Charging
voltage/current DC42.0V 2A
Battery
Model 36V 8AH Drive Mode PAS
Range 20-40km Operating
Temperature -10

Page
6
e
azi
-
rider
-
City
Operation
Motor Controller
The controller has 3 settings; low – high.
Press the MODE button until the desired level is
illuminated.
Turning On and Off
Before turning on the controller make sure that
the battery is locked in place.
Hold down the ON/OFF button until the
controller illuminates.
Now press the LIGHT button on the controller so that the indicator is illuminated,
this will power the headlight and horn.
Headlight
The headlight is switched on and off by pressing the red light
button that is located on the left hand side of the handle bars.
Note: the headlight only works when the light setting on the
controller is turned on.
Horn
The horn button is located underneath the headlight button.
Press to sound.
Note: The horn only works when the light setting on the controller is turned on.
Pedal Assisted Level
The motor power will remain at the level previously selected until a new level is
set.
It is possible to use the bike with no assistance, simply leave the controller turned
off.
Note: The light and horn will not work if the controller is turned off.
Push Power Assistance
To activate, hold down the MODE button.
Shortly the bike will start to propel itself, up to 6km/h.
Release the button to stop.
e
azi
-
rider
-
City
Page
7
Folding the bike
Before folding the bike ensure that:
- The battery is turned off and the key removed.
- The rear wheel is locked and the key removed.
- Place the right hand pedal downward (slightly ahead of vertical – 8 o’clock)
Handle Bars
- Open the middle quick release catch and lower the handle bars.
- Close the quick release catch locking the handle bars in position.
- Slide the safety ring from the lower release catch.
- Pull the release catch down folding the handle bars to the side.
Seat
- Open the quick release catch and lower the seat completely.
- Close the quick release catch locking the seat in position.
Frame
- Open the quick release locking catch and pivot away from the frame.
- Lift the locking catch, note this is spring loaded and can be a little stiff, and
partially fold the bike so that the catch can be released and the bike remains
hinged open.
- Close the kick stand and keep hold of the bike to prevent it from falling over.
- Now complete the folding process.
Reverse the process to re-assemble the bike ensuring that all the safety catches
are securely located.