DuraVent Type B User manual
Type B Gas Vent
Installation Instructions
C A ME R A -R E A DY L OG O T Y P E – U L MA R K F OR C A NA DA A ND T H E U .S .
These Marks are registered by Underwriters L aboratories I nc.
The minimum height of the registered trademark symbol ® shall be 3/64 of an inch. W hen the overall diameter of the
UL Mark is less than 3/8 of an inch, the trademark symbol may be omitted if it is not legible to the naked eye.
The font for all letter forms is Helvetica Condensed B lack, except for the trademark symbol ® , which is
Helvetica Condensed Medium. No other fonts are acceptable.
200-195C 20M/11/97
Type B Gas Vent
Figures 1, 2, & 3
A 1-inch
clearance (air space) to combustible
materials must be maintained, when using
DuraVent Round B-Vent, regardless of the
pipe diameter.
Step 3 or 4
Figures 6, 7, and 8.
Table 1Figure 4.
Figure 5
Figure 9
Figure 10
Figures 2 and 3
(Figure 11)
Figure 1
Figure 11
(Refer
to Table 2)
(Figure 12)
Table 2 (see next page)
Figure 14
(Figure
13)
Figure 15
Figure 16
Figure 17
Figure 16
Figure 18
DO NOT
Figure 19
(Figure 10)
Figure 20
Figure 21
Figure 22,
Figure 23
(Figure 24)
(Figure 30)
(a) Measurements.
Figure 25
(b) Pipe and Fitting Requirements.
GAS FIREPLACE
FLEX PIPE
FLASHING
STORM COLLAR
WITH SCREWS
(c). Connector.
Figure 26
Figure 27
(d). Flex Pipe Assembly.
Figure 28
(e). Position and Connect Fireplace.
(f). Adjust Height.
A
B
C
Table 2
(g). Flashing.
(Figure 28).
(h). Storm Collar.
(Figure 29)
(i). Termination Cap.
Figure 28
SCREWS
USE (3)¼" SCREWS. DO NOT
PENETRATE INNER WALL
TOP VIEW
SIDE VIEW
MASONRY
ANCHORS
NON-HARDENING
SEALANT
SEALANT
NON-
HARDENING B-VENT PIPE
SECTION
STORM COLLAR
TALL CONE FLASHING
(a). Locate Appliance.
Figure 30
(b). Hole in Masonry.
(c). Tee.
Figure 30
(d). Vertical Pipe Sections
opposite the hole in the masonry.
(e). Adjust Height.
Table 2
(f). Flashing.
(Figure 28).
(g). Storm Collar.
(Figure 29)
(h). Horizontal Pipe Section(s).
TEE
TRIM COLLAR
OPTIONAL
HIGH WIND
CAP
FLASHING
STORM COLLAR
WITH SCREWS
DRAFT HOOD
CONNECTOR (IF
REQUIRED)
GAS
APPLIANCE
(i). Insulation.
Figure
31
Table
2.
(a)
(b)
Table 1
*THIS REQUIREMENT COVERS MOST INSTALLATION
This manual suits for next models
1
Table of contents
Other DuraVent Ventilation Hood manuals
DuraVent
DuraVent FasNSeal W2 User manual
DuraVent
DuraVent DuraChimney II User manual
DuraVent
DuraVent DAS1 User manual
DuraVent
DuraVent DURAPLUS CANADA 2 User manual
DuraVent
DuraVent DuraTech Series User manual
DuraVent
DuraVent SELKIRK Ultimate StovePipe USP User manual
DuraVent
DuraVent DURASTACK PRO DAS1 Series User manual
DuraVent
DuraVent DuraTech User manual
Popular Ventilation Hood manuals by other brands
XO Appliance
XO Appliance XOI21SC manual
Gurari
Gurari GCH B 051 Instruction manual for installation and use
Hankel
Hankel DKE 316 user manual
Spring Air Systems
Spring Air Systems DN REV-LOW Maintenance and operating manual
Amica
Amica UH Series instruction manual
Electrolux
Electrolux EFC 9408 EFC 6404 Operating and installation instructions
