Durovin Bathrooms DR04 User manual

1
DR04
Ravenna 17-2nd L shape

2
Table of Contents
Included Parts..........................................................................................3
Tools Required.........................................................................................4
Sealing strip and brackets assembly.........................................................5
Glass side panel assembly........................................................................6
Glass door panel assembly.....................................................................10
Apply silicone sealant ............................................................................12

3
Included Parts
Ref
Description
Illustrations
Qty
Ref
Description
Illustration
Qty
①
Bottom Seal
1
⑫
Glass Door
1
②
Fixing Pieces
(R/L) 1
⑬
Caps
2
③
Screws
2
⑭
Door Seal
1
④
Door Seal
1
⑮
Top Rail Brackets
2
⑤
Glass Panel
1
⑯
Top Rail End Plate
1
⑥
Brackets
4
⑰
Glass Panel
1
⑦
Side Panel Seals
2
⑱
Handles
1
⑧
Caps
2
⑲
Screws
6
⑨
Wall Plugs
6
⑳
Fixing Pieces
(R/L) 1
⑩
Top Rail
1
㉑
Wall Plugs
2
⑪
Door Rollers
2

4
Tools Required
Two people required. We recommend that a technically competent installer should
undertake this installation.
Be sure you have all included parts and tools required before beginning installation
and that you have plenty of space for assembly.
If you have ordered this shower enclosure with one of our shower trays, please note
that tiling should be done before the shower tray is installed. This is so that the shower
tray can be pushed up against the tiles and sealed with silicone.
PRE-INSTALLATION AND TECHNICAL REQUIREMENTS
•All dimensions are shown in millimetres, except where otherwise indicated.
•Ensure that the enclosure set is fitted to a level floor and vertical wall surface.
•This instruction manual is applicable for both pre-tiled wall and plain walls.
•The wall fixings included with this product are suitable for solid walls only.
Plasterboard or stud walls may require specialist fixings (not supplied).
•Due to the possibility of residual spray, the area around the outside of the
shower tray should be tiled, or made otherwise water resistant.
IMPORTANT SAFETY NOTES
•Under no circumstances should you attempt to drill through the glass, damage or
injury may occur
•Please handle all glass with care, avoiding knocks and shock loading to all sides
and edges. Safety glass cannot be reworked.
•Care should be taken when drilling into walls to avoid hidden pipes or electrical
cables.

5
Sealing strip and brackets assembly
1. Attach both side panel seals to the glass side panels.
2. Attach the four brackets to the glass side panels.

6
Glass side panel assembly
3. Measure and mark where the glass side panels will be positioned.

7
4. Using a spirit level and a pencil, be sure that the side panels will be level before marking
where holes will be drilled for the brackets and top rail.

8
5. Drill holes and insert wall plugs.
6. Carefully lift and screw the glass side panels onto the walls.

9
7. Screw the top rail brackets to the wall and opposite glass side panel, attaching the top
rail and tightening into place.
8. Attach the top rail to the glass panel is it sitting against for added support.
9. Drill holes into the shower tray or floor for the side panel fixing pieces, insert plugs and
screw the fixing pieces into place.

10
Glass door panel assembly
10. Attach the rollers to the door.
11. Carefully lift the glass door onto the top rail, being sure that it slots into the fixing piece
on the floor.

11
12. Attach seal to the glass door.
13. Attach handles to the glass door.

12
Apply silicone sealant
14. Attach caps onto brackets and rollers.
15. Silicone around the bottom of the glass, allowing it to dry for 24 hours.