Durovin Bathrooms Ravenna 17-2nd U Shape User manual

Ravenna 17-2nd U Shape

Table of Contents
Included Parts..........................................................................................3
Tools Required.........................................................................................8
Glass side panel assembly........................................................................9
Glass door panel assembly.....................................................................11

Included Parts
Ref
Description
Qty
Ref
Description
Qty
Ref
Description
Qty
①
Handle
1
⑨
Glass Fixing Piece
1
⑰
Glass Side Panel
1
②
Door Rollers
2
⑩
Glass Fixing Piece
1
⑱
Bottom Door Seal
1
③
Support Bar
Brackets
2
⑪
Screws
3
⑲
Supporting Bar
1
④
Wall Plugs
3
⑫
Screws
4
⑳
Support Bar
Brackets
2
⑤
Anti-jump Cap
2
⑬
Glass Door Seal
1
㉑
Glass Side Panel
1
⑥
Anti-jump Roller
2
⑭
Glass Door Seal
1
㉒
Side Panel Seal
1
⑦
Brackets
4
⑮
Side Panel Seal
2
㉓
Glass Side Panel
1
⑧
Wall Plugs
4
⑯
Glass Door
1
㉔
Brackets
2

Tools Required
Two people required. We recommend that a technically competent installer should
undertake this installation.
Be sure you have all included parts and tools required before beginning installation
and that you have plenty of space for assembly.
PRE-INSTALLATION AND TECHNICAL REQUIREMENTS
•All dimensions are shown in millimetres, except where otherwise indicated.
•Ensure that the enclosure set is fitted to a level floor and vertical wall surface.
•This instruction manual is applicable for both pre-tiled wall and plain walls.
•The wall fixings included with this product are suitable for solid walls only.
Plasterboard or stud walls may require specialist fixings (not supplied).
•Due to the possibility of residual spray, the area around the outside of the
shower tray should be tiled, or made otherwise water resistant.
IMPORTANT SAFETY NOTES
•Under no circumstances should you attempt to drill through the glass, damage or
injury may occur
•Please handle all glass with care, avoiding knocks and shock loading to all sides
and edges. Safety glass cannot be reworked.
•Care should be taken when drilling into walls to avoid hidden pipes or electrical
cables.

Glass side panel assembly
1. Attach seals to the end of the side panels where it will touch the wall.
2. Attach all four brackets to the same ends of the side panels.
3. Carefully and individually lift the side panels into place, marking on the wall
where holes will be drilled to attach the brackets.
4. Drill holes and insert wall plugs.
5. Carefully screw the side panels onto the wall.

6. Attach the seal to side panel.
7. Carefully lift the side panel into place and attach the brackets.

Glass door panel assembly
8. Screw the support bar end plate into place.
9. Lift the support bar into place, attaching it to all three side panels.
10. Slide seals onto the glass door and attach the rollers.

11. Mark where the glass fixing piece will be placed.
12. Drill hole and insert plug.
13. Attach the handles to the glass door.
14. Slide glass fixing piece into place.

15. Mark where the hole for the glass fixing piece will need to be drilled.
16. Drill hole and insert plug.
17. Screw the fixing piece into place.
18. Adjust and tighten the glass door rollers if needed.
19. Attach the anti-jump rollers.

20. Attach caps on the inside of all brackets to protect against water.