Durovin Bathrooms Ravenna 17 User manual

Ravenna 17 Door Only

Table of Contents
Table of Contents.....................................................................................2
Included Parts..........................................................................................3
Tools Required.........................................................................................4
Aluminium Profile assembly.....................................................................5
Glass side panel assembly........................................................................8
Glass door panel assembly.....................................................................10
Apply silicone sealant ............................................................................12

Included Parts
Ref
Description
Illustrations
Qty
Ref
Description
Illustration
Qty
①
Bottom Door Seal
1
⑩
Supporting Bar
1
②
Glass Fixing Piece
(R/L) 1
⑪
Door Rollers
2
③
ST4*40
2
⑫
Glass Door
1
④
Door Seal
1
⑬
Supporting Bar
Stabilisers
2
⑤
Glass Side Panel
1
⑭
Door Seal
1
⑥
Aluminium Profile
1
⑮
Supporting Bar
Bracket
2
⑦
Supporting Bar
Fixing Pieces
1
⑯
Handle
1
⑧
Wall Plugs
2
⑰
Glass Fixing Piece
(R/L) 1
⑨
ST5*40
12
⑱
Wall Plugs
2

Tools Required
Two people required. We recommend that a technically competent installer should
undertake this installation.
Be sure you have all included parts and tools required before beginning installation
and that you have plenty of space for assembly.
PRE-INSTALLATION AND TECHNICAL REQUIREMENTS
•All dimensions are shown in millimetres, except where otherwise indicated.
•Ensure that the enclosure set is fitted to a level floor and vertical wall surface.
•This instruction manual is applicable for both pre-tiled wall and plain walls.
•The wall fixings included with this product are suitable for solid walls only.
Plasterboard or stud walls may require specialist fixings (not supplied).
•Due to the possibility of residual spray, the area around the outside of the
shower tray should be tiled, or made otherwise water resistant.
IMPORTANT SAFETY NOTES
•Under no circumstances should you attempt to drill through the glass, damage or
injury may occur
•Please handle all glass with care, avoiding knocks and shock loading to all sides
and edges. Safety glass cannot be reworked.
•Care should be taken when drilling into walls to avoid hidden pipes or electrical
cables.

Aluminium Profile assembly
1. Measure the distance from the wall to where your shower door will be fitted.

2. Place the aluminium profile against the wall, using a spirit level and a pencil to
mark where holes will be drilled.

3. Drill the holes and insert wall plugs.
4. Screw the aluminium profile onto the wall.

Glass side panel assembly
5. Place the supporting bar brackets in place on each wall, marking where holes will
be drilled.
6. Drill holes and insert wall plugs.
7. Screw the brackets to the walls.
8. Carefully lift the glass side panel into place

9. Attach the supporting bar to its brackets and the glass side panel.
10. Slide the glass fixing pieces into place, marking where holes will be drilled.
11. Drill holes, insert plugs and screw them into place.

Glass door panel assembly
12. Attach left seal to the glass door.
13. Attach rollers to the glass door.
14. Carefully lift the glass door into place.

15. Attach the right door seal.
16. Attach the handle to the glass door.
17. Tighten the rollers if necessary.

Apply silicone sealant
18. Insert caps onto the rollers.
19. Silicone and allow to dry for 24 hours.