Durovin Bathrooms Ravenna 2 User manual

1
Ravenna 2 Instructions

2
Table of Contents
Included Parts....................................................................................................3
Tools Required...................................................................................................4
Glass side panel assembly..................................................................................7
Glass door panel assembly.................................................................................8
Supporting bar assembly ...................................................................................9
Profile cap assembly ........................................................................................10

3
Included Parts
Ref
Description
Qty
Ref
Description
Qty
Ref
Description
Qty
①
Wall facing aluminium
2
⑦
Magnetic stripe
2
⑬
Stainless steel pads
6
②
Decorative aluminium
2
⑧
Side water retaining
strip
2
⑭
Pourable resin chock
6
③
Left fixed glass
1
⑨
Water under the door
2
⑮
Glass fixing piece
2
④
Left moving glass
1
⑩
Plastic expansion pipe
8
⑯
Stainless steel strut
2
⑤
Right fixed glass
1
⑪
ST4*40
8
⑰
Catch
1
⑥
Right fixed glass
1
⑫
M6*20
6
⑱
Hinge
4

4

5

6
Tools Required
Two people required. We recommend that a technically competent installer should
undertake this installation.
Be sure you have all included parts and tools required before beginning installation and that
you have plenty of space for assembly.
If you have ordered this shower enclosure with one of our shower trays, please note that
tiling should be done before the shower tray is installed. This is so that the shower tray can
be pushed up against the tiles and sealed with silicone.
PRE-INSTALLATION AND TECHNICAL REQUIREMENTS
•All dimensions are shown in millimetres, except where otherwise indicated.
•Ensure that the enclosure set is fitted to a level floor and vertical wall surface.
•This instruction manual is applicable for both pre-tiled wall and plain walls.
•The wall fixings included with this product are suitable for solid walls only. Plasterboard
or stud walls may require specialist fixings (not supplied).
•Due to the possibility of residual spray, the area around the outside of the shower tray
should be tiled, or made otherwise water resistant.
IMPORTANT SAFETY NOTES
•Under no circumstances should you attempt to drill through the glass, damage or injury
may occur
•Please handle all glass with care, avoiding knocks and shock loading to all sides and
edges. Safety glass cannot be reworked.
•Care should be taken when drilling into walls to avoid hidden pipes or electrical cables.

7
Glass side panel assembly
1. Check with a spirit level that the aluminium profile is level with the wall.
2. Mark with a pencil where holes will be drilled.
3. Drill holes and insert wall plugs.
4. Screw the aluminium profile onto the wall.
5. Install the glass panels onto the aluminium profile, remembering the use included
washers.
6. Install the hinges to the glass panels.

8
Glass door panel assembly
7. Carefully install both glass doors.
8. Insert the magnetic strips onto the glass doors.
9. Attach handles to the glass doors.
10. Attach the door seal strips to the bottom of each door.

9
Supporting barassembly
11. Adjust the magnetic door strips if needed, making sure that they are level.
12. Place supporting bars onto the side panels, using a pencil to mark where holes will be
drilled.
13. Drill holes and insert wall plugs.
14. Remove ends of supporting bars, screwing them onto the wall.
15. Attach support bar, screwing it into place.
16. Carefully drill holes into shower tray or floor for the glass fixing pieces, screwing them
into place.

10
Profile cap assembly
17. Tighten the fixed glass screws.
18. Attach the decorative aluminium bar.