dymax BlueWave Dymax Manual

Quick Start Instructions
BlueWave®LED Flood Lamp Mounting Stand Kit (41268)
Unpacking and Setup Instructions
1. Remove the stand and carriage from the packaging.
2. Remove the cap and 2 fasteners from the stand’s upright. These are push-in fasteners, not screws, and can
easily be removed by pushing upward on the plate (Figure 1).
3. Using a 2-mm hex key, remove the 2 outer screws from the back of the emitter. (Figure 2)
Figure 1. Remove Cap and Fasteners
Figure 2. Remove 2 Outer Screws from Emitter
4. Using a 4-mm hex key, attach the carriage to the emitter using the screws supplied with the carriage. (Figure 3)
5. Slide the carriage onto the stand upright, being sure to align bearing pads and t-nut into slot (Figure 4).
Figure 3. Attach the Carriage to the Emitter
Figure 4. Slide Carriage into Stand
Stand’s Upright
Cap
Fasteners (2X)
Remove 2 Outer Screws

© 2019 Dymax Corporation. All rights reserved. All trademarks in this guide, except where noted, are the property of, or used under license by Dymax Corporation, U.S.A.
Please note that most dispensing and curing system applications are unique. Dymax does not warrant the fitness of the product for the intended application. Any warranty applicable to the product, its application and use is strictly limited to that contained in
Dymax’s standard Conditions of Sale. Dymax recommends that any intended application be evaluated and tested by the user to ensure that desired performance criteria are satisfied. Dymax is willing to assist users in their performance testing and evaluation by offering
equipment trial rental and leasing programs to assist in such testing and evaluations. Data sheets are available for valve controllers or pressure pots upon request. 4/12/2019 QS085
Dymax Corporation
+1.860.482.1010 | i[email protected]om | www.dymax.com
Dymax Oligomers & Coatings
+1.860.626.7006 | [e-mail] | www.dymax-oc.com
Dymax Asia (H.K.) Limited
+852.2460.7038 | [e-mail] | www.dymax.com.cn
Dymax Europe GmbH
+49 (0) 611.962.7900 | [e-mail] | www.dymax.de
Dymax UV Adhesives & Equipment (Shanghai) Co. Ltd.
+86.21.37285759 | [e-mail] | www.dymax.com.cn
Dymax Asia Pacific Pte. Ltd.
+65.6752.2887 | inf[email protected] | www.dymax-ap.com
Dymax Engineering Adhesives Ireland Ltd.
+353 21.237.3016 | [e-mail] | www.dymax.ie
Dymax UV Adhesives & Equipment (Shenzhen) Co. Ltd.
+86.755.83485759 | [e-mail] | www.dymax.com.cn
Dymax Korea LLC
+82.2.784.3434 | [e-mail] | www.dymax.com/kr
6. Slide to the desired height, tighten the thumbscrew.
7. Slide back panel into position.
8. Replace the cap and fasteners.
Figure 5. Slide back panel into position
Figure 6. Replace cap and fasteners
9. Further information regarding the use of this system can be found in the following:
BlueWave®LED Flood System Product Bulletin (PB041)
BlueWave®LED Flood System User Guide (MAN067)
Using a BlueWave LED Flood System with an Acrylic Shield Quick Start (QS072)