Dymo LabelWriter 400 Duo Guide User manual

Network printing
on a Dymo LabelWriter 400 Duo
with the SX-2000WG
This is a step by step manual how to install the print server SX-2000WG
to network the Dymo LabelWriter 400 Duo.
The setup is exactly the same for the SX-2000U2 and the SX-1000U.
Dymo LabelWriter 330 Turbo, 320, 310, 400 Turbo, 400, 400 duo
are supported by these silex print servers:
SX-5000U2, SX-1000U, SX-2000U2, SX-2000WG, SX-3700WB.
SX-5000U2 and SX-3700WB use different printing methods –
please use JC-Print Port 2002 or printing over NetBios
(different step by step manual is available at [email protected]).

Before you start:
This setup shows how it works on „Dymo LabelWriter Software Version 7.0 for
Windows“ – lower versions might vary.
Configure the SX-2000WG to make it available on the network
(Quicksetup e.g.).
Connect SX-2000WG to the network and to your Dymo LabelWriter.
Install the SX-Virtual Link application.
( SX-Virtual Link Version 1.3.0 is used in this setup – older versions might not have the auto connect feature)
Download latest version from our website:
http://www.silexeurope.de/euro/support/printserver/virtuallink.html

Please start SX-Virtual Link first, then start the setup from
CD – choose your language.
It is important that you start SX-Virtual Link for later

If necessary please adjust the path

Now press ALT + TAB to switch between the processes
(keep ALT pressed and switch with TAB)

Switch so SX-Virtual Link