Dynamic Accents 52250 Parts list manual

36” Tall Pressure Mount Doorway Gate
Instruction/Installation Guide
Thank You for choosing the Dynamic Accents Ltd. 36” Tall Pressure Mount Pet Gate for your pet containment
needs. Please keep this guide for future reference on installation of this product.
This product is proudly Made in the U.S.A. of solid White Oak and coated with non-toxic. water based finish.
Your Package Includes the following:
This gate spans openings of 32” to 38” wide. For coverage of wider openings
up to 62” total, optional 6” and 12” extension kits are available for purchase.
2” Gate
Extensions
(x2)
36” Tall Pressure Mount
Pet Gate with wall bumpers
Connector
Bolts (x4)
Gate frame is intentionallywider
at the top because of the tension
design of the product. Bringing
the frame into alignment with the
gate door during installation
creates the tension effect to hold
the gate in place.
Gate door is affixed to frame with
spring hinges which apply
downward pressure to securely
latch the gate door to the bottom
frame. To open door, grasp top
rail, lift entire door slightly and
door will swing freely in either
direction.
Measure the opening to determine the width of coverage needed
and choose the appropriate parts needed based on the diagrams below:
Openings
32” to 34” wide
Openings
34” to 36” wide
Openings
36” to 38” wide Is your opening more
than 38” wide?
STOP
You will need additional
extensions to cover
openings larger than 38”
wide. Improper
installation could result
in unexpected accident
or product damage.
Hex Key
Use Gate Only and adjust
wall bumpers for secure fit
Use Gate plus (1) 2”
Extension and adjust wall
bumpers for secure fit
Use Gate plus (2) 2”
Extensions and adjust wall
bumpers for secure fit

•NEVER use this product at the top of a staircase
•Install this product on a level, even surface with smooth walls.
•Keep gate door securely closed when not in use.
•Do not lean or sit on this product.
•Keep this product away from fire or extremely high temperatures.
•Do not use this product for anything other than its intended purpose.
•Use only mild detergent and water to clean this product.
For consumer comments or concerns
please contact:
Dynamic Accents customer service at:
866-354-7334
Or
[e-mail]
See more of our exciting
products at:
www.dynamicaccents.com
How to install the gate:
1. Affix any necessary extensions to the main gate frame utilizing the connector bolts and
included hex key.
2. Determine the desired direction for the door opening and set the gate against the wall/door
frame at a square, right angle, ensuring that the gate frame bottom bumpers are firmly on
the floor. (The top of the frame may likely be wider than the opening, so use minimal force
to pull the wide, outer frame top into square alignment.
3. Adjust top, door opening bumper to bring door frame into alignment so that gap between
door and frame is consistent from bottom to top.
4. Adjust the remaining wall bumpers outward equally to create enough force to securely
hold the gate in place, again ensuring that the gate frame bottom bumpers are firmly on
the floor.
5. Open and close gate several times to ensure a snug, secure fit. Make minor bumper
adjustments equally to each side and the bottom as needed.
CAUTIONS:
To Span Larger Openings:
If you would like to span openings larger than 38” the following extension kits
are available for purchase:
Item# 52251
6” Gate Extension Kit
Comes complete with
(2) 6” gate extension
panels and all hardware
needed to increase gate
span to 50 total inches.
Item# 52253
12” Gate Extension Kit
Comes complete with
(2) 12” gate extension
panels and all hardware
needed to increase gate
span to 62 total inches.
***It is NOT recommended that this gate be used to
span openings larger than 62” total.