EasyPro Mag Drive Use and care manual

Mag Drive Pumps
Instructions for Operation • Safety • Warranty
Thank you for purchasing the EasyPro Mag Drive pump.
This pump is a magnetically driven water pump. It contains no
oil, rotating shafts, shaft seals or bearings. This pump combines
simplicity of design with the most energy ecient operation of
any pump. All electrical components are encapsulated in epoxy.
The impeller assembly consists of impeller blades attached to a
magnet and is easily replaced should the need arise. There are
threaded discharge and intake ports on all models.
Safety & Electrical Connections
1. Always disconnect the electrical supply before handling, maintaining, repairing or installing any
pond equipment.
2. Connect this product only to a 110 volt receptacle that is protected by a Ground Fault Circuit Interrupter
(GFCI).
3. The pump must be fully submersed underwater at all times when operating.
4. Never let the pump run dry, as this can damage the impeller, over heat the pump and possibly burn out
the pump.
5. Do not use this product in bathrooms or swimming pools.
6. All electrical work must be performed by a qualied technician. Always follow the National Electrical
Code (NEC) or the Canadian Electrical Code as well as all local, state and provincial codes. Code
questions should be directed to your local electrical inspector. Failure to follow electrical codes
and OSHA safety standards may result in personal injury or equipment damage. Failure to follow
manufacturer’s installation instructions may result in electrical shock, re hazard, personal injury or
death, damaged equipment, provide unsatisfactory performance, and may void manufacturer’s warranty.
7. When installing ttings into the pump, do not overtighten as this could crack the housing and void
the warranty.
8. Do not remove the pre-lter or the pre-lter cover from the pump as this will cause excess debris to
enter the pump and may void the warranty.
Troubleshooting:
If the pump fails to operate, please check the following before contacting EasyPro:
Note: Always disconnect from electrical outlet before handling the pump.
1. Check the GFCI circuit breaker or try another GFCI electrical outlet to ensure the pump is getting power.
2. Check the tubing for kinks and obstructions. Check lter cover and foam lter for blockage. Follow
cleaning steps in the maintenance section if blockage is suspected.
3. If necessary, remove and clean the impeller assembly.
EP120 • EP200 • EP400 • EP600 • EP850
EP1050 • EP1350 • EP1750 • EP2200 • EP3200N
1
Components included with EP1350, fountains may vary

Service & Maintenance See our website for a video about Mag Drive Pump Impeller
Replacement
1. Disconnect all power supplies before service.
2. It is highly recommended to place the pump in either an EasyPro skimmer or into an EasyPro
pump protector.
3. Clean the intake screen and foam lter when the ow is visibly reduced.
4. Clean the pump and impeller with clean fresh water.
5. When cleaning the pump and impeller, be careful not to loose the small plastic washers
positioned at the top and bottom of the impeller. These washers are critical to the quiet and
ecient operation of the pump.
6. Check inside the impeller housing for large debris or algae that could reduce the ow.
7. Clean the impeller housing using cotton swabs. Clean the outside of the impeller with a damp
cloth and clean water. A vinegar mixture may help remove hard deposits.
Operation of Pumps & Attachments
These versatile pumps have threaded inlets and outlets for connecting tubing. Fittings are included
to connect to a exible tubing or PVC ttings can be used to connect to PVC pipe. Always be careful
not to overtighten ttings into the pump.
Mag Drive pumps can be used in a wide variety of water features or pond applications. Pumps may
be used in almost any position including on their side if used in basins or other tight spaces.
EP120 to EP1350 units include fountain nozzle sets and can be used as their own water feature.
EP400 to EP1350 nozzle sets include ow diverters that allow for operating the included nozzle with
the option to divert ow to another small water feature. Note: not all pumps come with all fountain
nozzles. See chart on following page for details.
Part # Foam Filter # Impeller Part #
EP120 EP120F EP120I
EP200 EP200F EP200I
EP400 EP400F EP400I
EP600 EP600F EP600I
EP850 EP850F EP850I
EP1050 EP1050F EP1050I
EP1350 EP1350F EP1350I
EP1750 N/A EP1750I
EP2200 N/A EP2200I
EP3200N N/A EP3200IN
Replacement Parts for the EP120 — EP3200N Mag Drive Pumps
2
See our website for video of How to Replace an Impellar

Fountain Nozzles Included with Mag Drive Pumps
EP120 EP200 EP400 EP600 EP850 EP1050 EP1350 EP1750 EP2200 EP3200N
Waterbell x x x x x x x NA NA NA
Volcano x x x x x x x NA NA NA
Double Volcano x x x x NA NA NA
Foaming Jet x NA NA NA
Flow Control Valve 3/8" 1/2" NA NA NA
Diverter Valve 1/2" 1/2" 3/4" 3/4" 3/4" NA NA NA
3
Actual nozzles may dier from images shown
Fountain Nozzle and Fitting Sets
EP120 EP200
EP400 / EP600 (shown)
EP400: no double volcano
EP850/ EP1050 / EP1350 (shown)
EP850 / EP1050 no foaming jet nozzle
See our website for videos of EasyPro Fountain Nozzles
Foam Jet
Swivel base, 53/4" tall
EFN1
Water Bell
61/2" tall
EFN2
Double Volcano
71/2" tall
EFN4
Volcano
13/4" tall
EFN3

EasyPro Pond Products Limited Warranty
EasyPro Pond Products (“EasyPro”) warrants to the purchaser that this product (“Product”) will be free from any mechanical or
material defects for a period of:
Pump: three years from the date of purchase.
Impeller: six months from the date of purchase.
This warranty only covers properly installed and maintained Products sold by authorized EasyPro Sellers who are subject to and
follow EasyPro’s quality control standards. Please note that because EasyPro is unable to control the quality of Products sold by
unauthorized sellers, unless otherwise prohibited by law, this warranty does not cover Products purchased from unauthorized
sellers.
This warranty does not cover normal wear and tear, nor any deterioration suered through overloading, improper use, negligence,
improper installation, acts of God or accident. Similarly, any modication made by the purchaser to the Product will cause the
warranty to be null and void. This warranty does not cover any cost associated with the installation or removal of the Product
subject to a warranty claim.
All returned items will be inspected to determine cause of failure before a warranty claim is approved.
The exclusive remedies provided hereunder shall, upon EasyPro’s inspection and option, be either repair or replacement of the
Product or parts covered under this warranty.
Making a Claim: A Return Authorization (“RA”) number must rst be obtained by calling EasyPro at 800-448-3873 or via email
at [email protected]. It is the purchaser’s responsibility to pay the return shipping charges. Be sure to include the RA
number, original receipt (in the form of an invoice or sales receipt), your name, your return address and your phone number inside
of the package. No warranty claims will be honored without the original receipt that shows that your purchase was made from
an Authorized EasyPro Seller. Ensure the product is properly packaged and insured for the replacement value. Damage due to
improper packaging is the responsibility of the sender.
ALL OTHER EXPRESS OR IMPLIED WARRANTIES INCLUDING MERCHANTABILITY OF FITNESS FOR A PARTICULAR
PURPOSE ARE HEREBY LIMITED IN DURATION TO THE DURATION OF THE WARRANTY AS DESCRIBED ABOVE. Some States
do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.
EasyPro shall not be held liable for any damages caused by defective components or materials of this Product; or for loss
incurred because of the interruption of service; or any consequential/incidental damages and expenses arising from the
production, sale, use or misuse of this Product. Some States do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
EasyPro shall not be held liable for any loss of sh, plants or any other livestock as a result of any failure or defect of this Product.
This warranty gives you specic legal rights, and you may also have other rights that vary from State to State.
800-448-3873 • Grant, Michigan
www.easypro.com
7605 10/19