Eaton Powerware 5125 Operating and safety instructions

1000 - 2000VA
User’s Manual 1019297 RevisionA
18
Use the following procedure to replace internal batteries:
1. Remove the UPS front panel by pulling the top.
2. Slide up and remove the metal battery cover.
3. 1000 VA units. Disconnect the red battery cable on the front of the battery. Pull the
battery out onto a flat, stable surface. Disconnect the black battery cable on the rear
of the battery, then on the front of the battery. Disconnect the red battery cable on
the rear of the battery. See “Recycling the Used Battery” on page 20 for proper
disposal.

1000 - 2200VA
User’s Manual
1019297
Revision A 19
4. 1500 and 2200 VA units. Pull the battery out onto a flat, stable surface. Press on the
black tab on the battery cable connector to disconnect the battery. See “Recycling
the Used Battery” on page 20 for proper disposal.
5. Install the new batteries in the reverse order of removal.
6. Reinstall the metal battery cover removed in Step 2. Replace the front panel.
Testing New Batteries
Press and hold the button for three seconds to initiate a self–test. After the test is
finished, the indicator should turn off. If the indicator stays on, check the battery
connections.Callyourservicerepresentativeif theproblempersists.