SPECIFICATIONS SM200iH
DIMENSIONAL DRAWING A & E SPECIFICATIONS
One Main Street, Whitinsville, MA 01588 508 234 6158 Toll Free 800 992 5013 FAX 508 234 8251 info@eaw.com www.eaw.com
EAW products are continually improved. All specifications are therefore subject to change without notice. SM200iH/2 pp October 2001 Printed in USA
The two-way full range loudspeaker systems shall incorporate
a 12-in LF transducer and a 2-in exit compression driver HF
transducer.
The LF driver shall be mounted in a vented enclosure tuned for
optimum low frequency response. The HF driver shall be
loaded on an axis-symmetrical wave guide plate with a nom-
inal coverage pattern of 90° (conical). An internal passive fil-
ter network shall provide fourth order acoustical crossover and
system equalization.
System frequency response shall vary no more than ±3 dB from
75 Hz to 18 kHz measured on axis. In passive mode, the loud-
speaker shall produce a Sound Pressure Level (SPL) of 98 dB
SPL on axis at 1 meter with a power input of 1 Watt, and shall
be capable of producing a peak output of 131 SPL on axis at
1 meter. It shall handle 500 Watts of amplifier power (con-
tinuous) and shall have a nominal impedance of 6 Ohms.
In bi-amped mode, the low frequency section shall meet all
passive mode performance criteria. In addition, the high fre-
quency section in bi-amped mode shall produce a Sound
Pressure Level (SPL) of 104 dB SPL on axis at 1 meter with a
power input of 1 Watt, and shall be capable of producing a
peak output of 133 SPL on axis at 1 meter. The high frequen-
cy section in bi-amped mode shall handle 200 Watts of ampli-
fier power (continuous) and shall have a nominal impedance
of 10 Ohms.
The loudspeaker enclosure shall be irregularly trapezoidal in
shape and shall have rubber footpads on two sides allowing
its baffle to be angled up 40° or 15°. The enclosure shall be
available in mirror-imaged right/left configurations. It shall
be constructed of multi-ply, void-free cross-grain-laminated
Baltic birch plywood and shall employ extensive internal brac-
ing. It shall be finished in black catalyzed polyurethane.
Input connectors shall be dual Neutrik NL4 Speakon. The sys-
tem shall include a switch allowing it to be operated in bi-
amp or passive powering mode. The front of the loudspeaker
shall be covered with a vinyl coated perforated steel grille
backed with open cell foam to protect against dust.
The two-way full range loudspeaker shall be the EAW model
SM200iH. (Specify left or right.)
Manufacturing tolerances are +/- 0.13 and +/- 1°
510173
10/24/96
