EBA 430 E User manual

EBA 430 E
EBA 430 EP
EBA • Made in Germany
• EBA Krug & Priester • 72336 Balingen • Germany • www.eba.de •
Document Shredders
Trimmers and Guillotines
Operating Instructions
Printed in Germany •EBA 04/2002 •DPrinted in Germany •EBA 04/2002 •D

EBA 430 E • EBA 430 EP
-3-
EBA 430 E • EBA 430 EP
-2-
Dear customer,
Thank you for choosing a paper cutting machine from EBA.With the purchase of this
quality product you can be sure you have made a good choice.
Please read these operating instructions before putting the machine into operation
and observe the safety regulations.
Read through the operating instructions
carefully
Table of contents
Pages
Safety precautions 4 – 11
Installation 12 – 13
Operation 14 – 25
Blade replacement 26 – 34
Maintenance and cleaning 35 – 36
Possible malfunctions 37 – 42
Accessories 43
Manufacturer´s Declaration 45

EBA 430 E • EBA 430 EP
-3-
EBA 430 E • EBA 430 EP
-2-
Dear customer,
Thank you for choosing a paper cutting machine from EBA.With the purchase of this
quality product you can be sure you have made a good choice.
Please read these operating instructions before putting the machine into operation
and observe the safety regulations.
Read through the operating instructions
carefully
Table of contents
Pages
Safety precautions 4 – 11
Installation 12 – 13
Operation 14 – 25
Blade replacement 26 – 34
Maintenance and cleaning 35 – 36
Possible malfunctions 37 – 42
Accessories 43
Manufacturer´s Declaration 45

EBA 430 E • EBA 430 EP
-5--4-
Children must not operate the machine!
Do not cut hard materials or materials which
may splinter!
The machine must not be located outside!
The machine must be installed on a sturdy, dry
and level floor!
Do not use in the vicinity of inflammable
liquids or gases!
Paper clips or hard material will damage the
cutting blade!

EBA 430 E • EBA 430 EP
-5--4-
Children must not operate the machine!
Do not cut hard materials or materials which
may splinter!
The machine must not be located outside!
The machine must be installed on a sturdy, dry
and level floor!
Do not use in the vicinity of inflammable
liquids or gases!
Paper clips or hard material will damage the
cutting blade!

EBA 430 E • EBA 430 EP
-7--6-
Never leave the blade unattended. Do not
dismount or transport the blade without
protection!
Risk of injury!
The machine may only be used for cutting
paper or similar materials! This machine is only constructed for "one-man operation"!
Disconnect from the mains before starting any
service work or before removing the panels!
Replacement of blade and cutting stick may
only be performed when the main switch is
switched off!

EBA 430 E • EBA 430 EP
-7--6-
Never leave the blade unattended. Do not
dismount or transport the blade without
protection!
Risk of injury!
The machine may only be used for cutting
paper or similar materials! This machine is only constructed for "one-man operation"!
Disconnect from the mains before starting any
service work or before removing the panels!
Replacement of blade and cutting stick may
only be performed when the main switch is
switched off!

EBA 430 E • EBA 430 EP
B
A
BC
A
≤15mm
≤0.59inch
-9--8-
A
AA
B
AC
C
Operating the machine without safety device
(front safety guard (A), rear screwed safety
guard (B) and panel (C) is forbidden!
The dangerous cutting movement is
safeguarded by a movable guard (A) and a
safety two-handed control system! (B)
Before working with the machine and after
every blade replacement the automatic cut-off
function of safety guard (A),(correct if distance
between cover and table is < 15 mm) main
switch (B) and control panel (C) must be
checked.
All components which may endanger the
operator are covered by a guard!

EBA 430 E • EBA 430 EP
B
A
BC
A
≤15mm
≤0.59inch
-9--8-
A
AA
B
AC
C
Operating the machine without safety device
(front safety guard (A), rear screwed safety
guard (B) and panel (C) is forbidden!
The dangerous cutting movement is
safeguarded by a movable guard (A) and a
safety two-handed control system! (B)
Before working with the machine and after
every blade replacement the automatic cut-off
function of safety guard (A),(correct if distance
between cover and table is < 15 mm) main
switch (B) and control panel (C) must be
checked.
All components which may endanger the
operator are covered by a guard!

EBA 430 E •EBA 430 EP
-11--10-
230 V / 10A min
115 V / 15A min
Protect mains cable against heat, oil and
sharp edges!
Connect the power cord to a single phase
socket
Ensure free access to mains
When not in use for a longer period switch off.
(Main switch to "0").