Edelbrock 15018 User manual

©2004 Edelbrock Corporation
Brochure #63-0344, Rev. 3/05
Catalog #15018
REPLACEMENT O-RING KIT
For Oil Supply Adapter #15010
Catalog #15018
INSTALLATION INSTRUCTIONS
®
PLEASE study these instructions carefully before installing your new Edelbrock Oil Supply Adapter. If you have any questions or problems, do not
hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-Friday, Pacific Standard Time or via e-mail at:
[email protected]. Please fill out and mail your warranty card.
•DESCRIPTION:
This kit includes three (3) replacement o-rings for oil supply adapter #15010 (Adapter #15010 is also used in Edelbrock Turbo Kits #1500,
1501, 1502, 1503, & 1504).
•KIT CONTENTS:
1 - Oil Adapter to Engine Block O-Ring
1 - Insert to Adapter Housing O-Ring
1 - Supply Fitting to Adapter Housing O-Ring
Installation Procedure
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: [email protected]
1. Disconnect your supply line from the adapter, remove oil filter (replace), and remove Oil Supply Sandwich Adapter using a 1/2” Allen wrench.
2. Dissasemble the adapter and replace o-rings (See Figure 1).
3. When reinstalling the adapter, make sure the adapter to engine block o-ring is facing toward the engine block, and the threaded stud with ½”
hex opening is facing out.
4. Tighten with a ½” Allen wrench. Make sure the blue fitting is facing toward the driver’s side, pointing upward slightly, about the 10 o’clock
position.
5. Install a new oil filter.
6. Reattach your supply line.
Replace O-Ring Under -6AN Fitting
Replace Large O-Ring On Engine
Block Side of Adapter
Towards Engine Block
Carefully Press Out the
Threaded Center of Supply
Adapter and Replace O-Ring
FIGURE 1 - Oil Supply Adapter