EGO Power+ Nexus Escape PAD1500E User manual

WARNING: To reduce the risk of injury, the user must read and understand the
Operator’s Manual before using this product. Save these instructions for future reference.
OPERATOR’S MANUAL
56-VOLT
POWER INVERTER
MODEL NUMBER PAD1500E

B
A
1. Power Button
2.Handle
3. USB Port2
4. USB Port1
5. AC Port 7.Spring Latch
6.Negative Electric
Contacts
Assemble
Separate
Mounting slot
8.Positive Electric
Contacts

56 VOLT POWER INVERTER — PAD1500E 3
READ ALL INSTRUCTIONS!
READ OPERATOR’S MANUAL
Residual risk! People with electronic devices, such
as pacemakers, should consult their physician(s) before
using this product. Operation of electrical equipment
in close proximity to a heart pacemaker could cause
interference or failure of the pacemaker.
WARNING: To ensure safety and reliability, all
repairs should be performed by a qualified service
technician.
WARNING: This appliance is not intended for
use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
SAFETY SYMBOLS
The purpose of safety symbols is to attract your attention
to possible dangers. The safety symbols and the
explanations with them deserve your careful attention
and understanding. The symbol warnings do not, by
themselves, eliminate any danger. The instructions and
warnings they give are no substitutes for proper accident
prevention measures.
WARNING: Be sure to read and understand all
safety instructions in this Operator’s Manual, including all
safety alert symbols such as “DANGER,” “WARNING,”
and “CAUTION” before using this tool. Failure to follow all
instructions listed below may result in electric shock, fire,
and/or serious personal injury.
SAFETY INSTRUCTIONS
This page depicts and describes safety symbols that may
appear on this product. Read, understand, and follow
all instructions on the machine before attempting to
assemble and operate.
Safety Alert Precautions that involve
your safety.
Read
Operator’s
Manual
To reduce the risk of injury,
user must read operator’s
manual
6.3A
fuse-links Time-lag miniature
fuse-link
Types of inverter Solated inverter
Indoor use Use this device indoors only
Class II
Construction
Double-insulated
construction
V Volt Voltage
A Amperes Current
Hz Hertz Frequency (cycles per
second)
WWatt Power
VA Voltage-Amperes Power
min Minutes Time
Alternating
Current Type of current
Direct Current Type or a characteristic of
current
WARNING: Read and understand all instructions.
Failure to follow all instructions listed below may result in
electric shock, fire and/or serious personal injury.
IMPORTANT SAFETY INSTRUCTIONS
◾Read all the instructions before using the product.
◾To reduce the risk of injury, close supervision is
necessary when the product is used near children.
◾Do not put fingers or hands into the product.
◾Use of an attachment not recommended or sold by the
manufacturer may result in a risk of fire, electric shock,
or injury to persons.

56 VOLT POWER INVERTER — PAD1500E4
◾Do not use a battery pack or appliance that is
damaged or modified. Damaged or modified batteries
may exhibit unpredictable behavior resulting in fire,
explosion or risk of injury.
◾When charging the battery, work in a well ventilated
area and do not restrict ventilation in any way.
◾Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from the
battery may cause irritation or burns.
◾Do not expose the battery pack to fire or excessive
temperature. Exposure to fire or temperature above
100°C may cause explosion.
◾Do not expose the power inverter to rain or wet
conditions. Water entering the power inverter will
increase the risk of electric shock.
◾The power inverter is not intended for any use other
than charging small (up to 4.2 Amp for two USB ports
combined) USB electronics or small (up to 150W) AC
devices. Any other use may result in damage.
◾Switch off the power inverter when not in use.
◾Use only with batteries listed below:
POWER
INVERTER BATTERY PACKS
PAD1500E
BA1400, BA2800, BA4200,
BA1400T, BA2800T,
BA4200T, BA5600T
◾Use the power inverter only with specifically
designated battery packs. Use of any other battery
packs may create a risk of injury and fire.
◾Do not disassemble the power inverter, take it to a
qualified service person when service or repair is
required. Incorrect reassembly may result in a risk of
fire or electric shock.
◾Have your power inverter serviced by a qualified
repairperson using only identical replacement parts.
This will ensure that the safety of the power inverter is
maintained.
◾Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If
you lend this tool to someone else, also lend these
instructions to them to prevent misuse of the product
and possible injury.
SAVE THESE INSTRUCTIONS!
SPECIFICATIONS
Input Voltage 56V
Range of rated values 37.8-58.8V
USB Output 5V, Max.4.2A (two USB ports
combined)
AC Output 220V-240V ~ 50Hz Max.150VA
Optimum Charging
Temperature 0°C-40°C
Storage Temperature -20°C-70°C
Weight 0.53 kg
DESCRIPTION
KNOW YOUR POWER INVERTER (Fig. A)
1. Power Button
2. Handle
3. USB Port2
4. USB Port1
5. AC Port
6. Negative Electric Contacts
7. Spring Latch
8. Positive Electric Contacts
OPERATION
WARNING: This device is intended to be used
indoors only. Use the inverter in dry environment.
WARNING: Do not modify or attempt to repair the
power inverter except as indicated in the instructions for
use and care.
The power inverter provides two USB ports and one AC
port. The two USB ports combined supply a maximum of
5V DC, up to 4.2 A output to power small USB devices, like
your cell phone, MP3 player, etc. The AC port supplies a
220V-240V AC, max.150W output to power the small AC
devices, such as a laptop computer.
NOTE: Fully charge your EGO POWER+ battery pack
before first use. The battery should be charged in a
location where the temperature is greater than 5°C and less
than 40°C.
1. Align the mounting slots on the power inverter with
the ribs on the battery pack, then move the power
inverter towards the battery pack until it snaps into
position (Fig. B).

56 VOLT POWER INVERTER — PAD1500E 5
NOTE: Make sure that the spring latch on the power
inverter snaps into place and the battery pack is secured
to the tool before beginning operation.
2. Connect the small USB or AC device to the power
inverter.
3. Press and hold the power button until the green light
in the button illuminates. The power inverter will
begin charging the device.
4. When not using or after charging, disconnect the
device from the power inverter, then press and hold
the power button until the green light turns off.
5. Hold the battery pack with one hand and pull the
power inverter with the other hand to separate them.
WARNING: Do not insert a nail, wire, etc. into the AC
power supply port, or the risk of electric shock may occur.
NOTE:
◾The product may not supply power to some USB
devices.
◾Do not insert a nail, wire, etc. into the USB power
supply port. Otherwise a circuit short may cause
smoke and fire.
◾If the devices connected to the power inverter draw
more than the rated output of the ports (Total 4.2A for
USB ports and maximum 150W for AC port), the power
inverter will shut off automatically and the power
button will flash red. In this situation, devices should be
removed. To reactivate the power inverter, press and
hold the power button until green light is illuminated.
◾When switching on the power inverter, if the USB
output current is less than 500mA and the AC output
power is less than 5W, the system will shut off
automatically in 1 minute.
◾When switching on the power inverter, if the USB
output current is beyond 500mA or the AC output
power is beyond 5W, but then the USB output current
is less than 500mA and the AC output is less than 5W
for 3 hours, the system will shut off automatically.
MAINTENANCE
WARNING: To avoid serious personal injury, always
remove the battery pack from the tool when cleaning or
performing any maintenance.
WARNING: When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc. come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
STORING THE UNIT
◾Remove the battery pack from the power inverter.
◾Clean the tool thoroughly before storing it.
◾Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of children. Do not store
the unit on or adjacent to fertilizers, gasoline, or other
chemicals.

56 VOLT POWER INVERTER — PAD1500E6
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The power inverter stops working
during use.
Battery capacity is depleted.
The battery pack is too hot.
Charge the battery.
Cool the battery pack until its
temperature drops below 67°C.
Red LED light on the power button
flashes for 1 minute, then shuts off.
The device(s) you are powering
draws more than the rated output
of the ports.
Remove the device and reactivate
the power inverter.
Red LED light on the power button
shines for 1 minute, then shuts off.
The device is too hot. Cool the power inverter until its
temperature drops below 105°C.

56 VOLT POWER INVERTER — PAD1500E 7
WARRANTY
EGO WARRANTY POLICY
5 year warranty on EGO outdoor power equipment and 3 year warranty on EGO Power+ System battery packs and
chargers.
Please contact EGO customer service on Australia 1300 000 EGO(1300 000 346),
New Zealand 0508 000 EGO (0508 000 346) any time you have questions or warranty claims.
SERVICE WARRANTY
FOR THREE YEARS from the date of original retail purchase, the EGO Power+ System Battery Pack and Charger are
warranted against defects in material or workmanship. Defective product will receive free repair.
This warranty applies only to the original purchaser at retail and may not be transferred.
The warranty period for any EGO product or part used for industrial, professional or commercial purpose is
one year.
This warranty is void if the product has been used for rental purpose.
This warranty does not cover the damage resulting from modification, alteration or unauthorized repair.
This warranty only covers defects arising under normal usage and does not cover any malfunction, failure or
defect resulting from misuse, abuse (including overloading of the product beyond capacity and exposure to
water or rain), accidents, neglect or lack of proper installation, and improper maintenance or storage.
This warranty does not cover normal deterioration of the exterior finish, including but not limited to scratches,
dents, paint chips, or to any corrosion or discoloring by heat, abrasive and chemical cleaners.
HOW TO OBTAIN SERVICE
For warranty service, please contact EGO customer service on Australia 1300 000 EGO(1300 000 346),
New Zealand 0508 000 EGO (0508 000 346). When requesting warranty service, you must present the original dated
sales receipt. An authorized service center will be selected to repair the product according to the stated warranty terms.
ADDITIONAL LIMITATIONS
Chervon Australia Pty Ltd ABN 36 165 077 501(“Chervon”) warrants to the original domestic purchaser that this
product will be free from defects in materials and workmanship for 5 years from date of purchase, and any battery or
charger will be free from defects in materials and workmanship for 3 years from date of purchase. To make a claim,
return the faulty item together with proof of purchase directly to your closest service agent or to the place of purchase.
Any handling and transportation costs (and other expenses incurred in claiming this warranty) are not covered by this
warranty and will not be borne by Chervon. The replacement product or part or repaired product will be made available
for your collection at an address nominated by Chervon. Where a valid warranty claim is made, Chervon will replace the
defective product or repair the fault. Where the product is repaired, Chervon may use refurbished parts. This warranty
does not cover normal wear and tear, misuse or abuse. This warranty may also be further limited or voided as
specifically detailed in the product Manual. Chervon has no other liability under this warranty.The benefits to you given
by this warranty are in addition to other rights and remedies imposed by State and Federal legislation that cannot be
excluded. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure. Chervon Australia Pty Ltd, Unit 14, 5 Kelletts Road, Rowville, VIC 3178.
Phone Number: Australia 1300 000 EGO(1300 000 346), New Zealand 0508 000 EGO (0508 000 346).
Email address: [email protected].