ekwb EK-Loop Modulus Series User manual

USER GUIDE
EK-Loop
Modulus Hard Tube Bending Tool – 12/14/16

- 2 -
This product is intended for installation only by expert users. Please
consult with a qualified technician for installation. Improper installation
may result in damage to your equipment. EK Water Blocks assumes
no liability whatsoever, expressed or implied, for the use of these
products, nor their installation. The following instructions are subject to
change without notice. Please visit our web site at for updates. Before
installation of this product please read important notice, disclosure and
warranty conditions printed on the back of the box or our home page.

- 3 -
TABLE OF CONTENT
BENDING TUBES 4
REQUIRED TOOLS 6
SUPPORT AND SERVICE 7
SOCIAL MEDIA 7

- 4 -
STEP 1:
First you need to put silicon insert inside your ACRYLIC/PETG tube.
You can use soap and a bit of water on silicon rod for easier installation.
STEP 1
BENDING TUBES
STEP 2:
Use industrial fan to heat up the ACRYLIC/PETG tube. You need to
rotate the tube while heating. You will notice that the tube is heated
enough when it starts to deflect under its own weight.
STEP 2
Industrial Fan
Silicon Insert ACRYLIC/PETG
Tube

- 5 -
STEP 3
Bend the tube around EK-Loop Modulus hard tube Bending tool.
When you force the tube into its final position leave hold it for about
15 seconds so that it hardens a bit. It is recommended to pull the
silicone rod out of the tubing when it’s still warm.
STEP 3
ACRYLIC/PETG Tube
STEP 4
You need to cut the tube to desired length. Use a fine hacksaw or
equivalent.
STEP 4
Saw

- 6 -
STEP 5
When finished you can use the tube reamer or sandpaper to chamfer
the edges for easier installation into the fittings.
STEP 2
REQUIRED TOOLS
Saw Industrial Fan

For assistance please contact:
http://support.ekwb.com/
EKWB d.o.o.
Pod lipami 18
1218 Komenda
Slovenia - EU
EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
ekwaterblocks
EKWBofficial
SUPPORT AND SERVICE
SOCIAL MEDIA