KNOW YOUR JUICE EXTRACTOR
MAIN PARTS
1. Pusher
2. Feeder tube
3. Protective cover
4. Grater and filter unit
5. Separating unit
6. Juice spout
7. Residue spout
8. Motor unit
9. Residue container
10. Safety lock
11. On/Off switch
12. Juice cup
SAFETY RECOMMENDATIONS
Read all the instructions thoroughly before
use.
Do not run the juice extractor continuously
for longer than 4 minutes. Switch Off and let
it rest for 2 minutes for the motor to cool
down before starting again.
Do not disassemble the appliance while
being plugged in.
Unplug the unit when not in use, before
cleaning or dismantling.
Close supervision is necessary when the
appliance is operated near children.
Do not place unit on or near gas or electric
burner or a heated oven.
Do not allow cord to hang over edge of table
or counter, or touch hot surface.
Do not leave the appliance unattended; do
not use the appliance other than its intended
use.
Always make sure the safety locks are
correctly clamped down before switching on.
Unit does not operate if locks are unfastened.
The unit is designed to shut off automatically
if locks are not fastened securely in place.
Do not use attachments other than those
which belong to this unit.
Do not put fingers or other objects into juicer
openings while it is in operation. If food is
lodged in feeder tube, use the pusher to
gently push it down.
Do not overload the appliance or use
excessive force to press food through the
feeding tube.
If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order
to avoid a hazard.
ADDITIONAL SAFETY
MEASURES RECOMMENDED
Do not leave packaging
components (plastic bags,
cardboard, polystyrene, etc),
within the reach of children, as
they could be dangerous.
BEFORE USING FOR THE FIRST TIME
Check the unit’s voltage is complying with
that of stated on the unit.
Practice assembling and dismantling the
unit a few times before adding fruit to
operate.
Dismantling and assembly
1. Dismantling
Turn switch to off, open the Locks (10).
Remove the Protective Cover (3).
Remove the Separating Unit (5), then pull
the Grater/filter unit (4) upwards.
2. Assembly
Place the Separating Unit (5) on Motor Unit
(8), push with both hands on the
Separating Unit until it is clicked into place.
Insert the Grater/filter Unit (4), turn it
clockwise until sits securely.
Mount the Protective Cover (3) and fastens
the Safety Locks (8).
Put the Residue Container (9) under the
Residue Spout (7), then set the Juice Cup
(12) under the Juice Spout (6).
OFF
ON
1
23
4
5
7
6
8
11
10
9
12
