13
•
•
•
•
ST1: display mile / km
ST2: speed limit in KM
ST3: wheel size (for speed / trip / ODO display on screen)
ST4: motor type (for speed / trip / ODO display on screen)
ST5: baery type (for baery meter display on screen)
ST6: assist level steps (default 0-5) – this controls how many notches you get – 3, 5, or 9, and what the
lowest seng is - a “0” seng that disables motor and PAS or 1 as the lowest.
ST7: current limit – controls the overall motor current maximum. This is for connuous. Peaks are al-
lowed to go above this by a couple amps. Turning down this seng essenally can reduce your “motor
waage” - you should set this to 20 usually
ST8: PAS sengs (see above)
ST9: Drive-mode sengs (Throle only / PAS only / both throle and PAS)
1-3 both (default)
1-1 PAS only (turn this on to disable throle. Alternavely you could just unplug the
throle… this could allow you to make the bike a California class 1 (20mph no throle) or class 3
(28mph no throle)
1-2 Throle only (or just unplug the PAS sensor)
VO-0 to VO-5: custom voltage sengs
Use this in conjuncon with ST5-DIY to ne-tune the voltage response for the baery meter
display or set up your own baery