Electrolux ELM 5250 User manual

ELM 5250 . EMS5010
EN

2
Components
A. ON/OFF button
B. Espresso button
C. Espresso lungo button
D. Lever
E. Capsule compartment
F. Water tank
G. Steam / hot water knob
H. Steam / hot water spout
I. Steam button
J. Coee spout
K. Cup support rack
L. Drip tray
M. Waste water indicator
N. Used capsules container
O. Power cord & plug
EN
A
B
C
D
E
F
G
H
I
J
K
M
N
O
L
No
EN
Espresso Machine ELM5250

3
Safety advice
Read the following instruction care-
fully before using the machine for the
first time.
• This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
•Children should be supervised to
ensure that they do not play with the
appliance.
•The appliance may only be connected
to a power supply whose voltage
and frequency comply with the
specifications on the rating plate!
•Never use or pick up the appliance if
– the supply cord is damaged,
– the housing is damaged.
•The appliance must only be connected
to an earthed socket. If necessary an
extension cable suitable for 10 A can
be used.
•If the appliance or the supply cord
is damaged, it must be replaced by
the manufacturer, its service agent or
similarly qualified person, in order to
avoid hazard.
• Always place the appliance on a flat,
level surface.
•Never leave the appliance unattended
while connected to the supply mains.
• The appliance and accessories
become hot during operation. Use
only designated handles and knobs.
Allow to cool down before cleaning or
storage.
•The mains cable must not come into
contact with any hot parts of the
appliance.
•When the steam function is used there
can be some hot water dripping from
the brewing head. DANGER! The water
is hot, there is a risk for scalding.
•When opening the steam valve there
is a shot of hot water coming out.
Be careful and open the steam valve
slowly. DANGER! The water is hot,
there is a risk for scalding.
•Do not immerse the appliance in
water or any other liquid.
•Do not exceed the maximum
volume as indicated on the appliances.
•Fill the water tank only with cold
water, never with milk or other liquids.
•Do not use the appliance if the water
tank has not been filled.
•Do not use the appliance without the
drip tray or the drip grid.
•This appliance is intended for domes-
tic use only. The manufacturer cannot
accept any liability for possible dam-
age caused by improper or incorrect
use.
•Do not carry machine by the handle.
•This machine can only be used with
Lavazza A MODO MIO capsules. Do not
put your fingers or any other object
in the capsule compartment. The cap-
sules can be used only once.
•If the steam function is used continu-
ously over 1 hour time period, there
must be a pause of 2 min after each
steam use, otherwise the lever can
become hot.
•Never switch on the machine with
steam/hot water knob in steam posi-
tion.
EN
EN
!
Getting started
1. Place the machine on a flat surface
and fill the tank with cold, drinkable
and non sparkling water. (The machine
must not be used with empty tank!)
Plug the power cord into the mains
and press the ON button. The machine
is ready to use when the cup indicator
lights stop flashing and become
steady.
2. When starting the machine for the
first time: Place a bowl under the
steam/hot water pipe and turn the
knob to the steam/hot water position.
Run ½ of the container and turn the
knob back.
3. The machine must not be used with
empty tank! If you use it without
water for a too long time the auto
priming could be blocked. To prime
the circuit, place a bowl under the
hot water pipe and turn the knob to
the steam/hot water position. When a
steady flow comes out from the pipe,
turn the knob back.

4
EN
Preparing coee
4. Lift the lever, insert a capsule in
the compartment. Close the lever
and press either Espresso or Espresso
lungo button. The machine will stop
automatically . When the coee is
ready, lift the lever and the capsule
falls down into the used capsules
container.
5. Programming coee amount. Place
a cup on the cup support rack. Press
and hold the espresso or espresso
lungo button. Release when desired
coee amount is reached. The
programmed quantity is memorized
by the machine.
1. Adjust the coee spout height for
dierent cup sizes by either pulling it
down or pushing it up.
The machine is equipped with
an energy saving function that
automatically switches it o after
30 min of inactivity.
3. A MODO MIO capsules. Only suitable
Lavazza “A MODO MIO” capsules
should be placed in the capsule
compartment. Single dose capsules
brew a single coee.
DO NOT use the capsules more than
once. Inserting 2 or more capsules can
cause the machine to malfunction.
2. Light. The machine is equipped with a
lamp which lights up the cup support
rack. The light will be on during the
brewing time and will switch o a few
seconds after the cup is ready.
30 min Auto-off

5
2. Steam can be used to froth milk
or to heat liquids. Press the steam
button. The light is flashing. When
steady, the machine is ready. Place
an empty container under the spout.
Turn knob to steam position for a few
seconds to purge residual water. Then
close the knob.
3. Fill 1/3 of a container with cold milk.
Immerse the steam spout into the milk
and turn the knob. Froth the milk by
swirling the container. When ready
turn the knob back. Caution: the
steam pipe is hot! Always use the
plastic handle when touching the
steam spout.
1. Preparing coee after steam. To
prepare coee, insert a capsule, close
the lever and press either the Espresso
or the Espresso lungo button (there is
a short cooling cycle before the coee
comes out).
Using hot water/Steam functions
Preparing coee after steam
EN
1. Hot water function. Place a cup under
the steam spout. Turn the knob to
steam/hot water position, and turn it
back to stop.

6
EN
Cleaning and care
1. Turn the machine o , unplug the
cord and let the machine cool down.
Wipe all outer surfaces with a damp
cloth. Rinse the water tank once a day.
2. When the floating indicator is visible
above the grid, the drip tray must be
emptied. Lift out grid, tray and waste
container. Empty, rinse, dry and put
back in place. This procedure should
be carried out every two or three days
or after 10 brewed coees.
Drip tray is not dishwasher proof
(paint can be damaged).
3. Cleaning the coee spout. Pull the
spout fully down and remove it by
pulling it towards you. Clean and put
back in place.
Cleaning the steam spout. After
using the steam spout, dispense steam
for a few seconds. Clean the spout
externally with a damp cloth. For an
easier cleaning, the pipe can also be
removed.
1. Decalcifying. We recommend to
decalcify the machine regularly
depending on the water hardness
(2–3 months). We recommend to
use Electrolux decalcifying solution
EPD4/C/D/E/N/R (never use vinegar).
Remove and empty the water tank.
Fill the water tank with decalcifying
solution (follow product instructions).
2. Place a bowl under the spout. Turn on
the machine. Press steam button for
3 sec., then turn the knob to steam/
hot water position (steam led and
coee led will flash alternately during
the 30 minute decalcifying process).
3. When the decalcifying process is
finished, steam led will flash fast
in order to remind the user to turn
the knob back. Rinse the water tank
properly, fill it with fresh water and put
it back. Place a bowl under the spout.
Open the knob and rinse machine
until the tank is empty.

7
EN
Troubleshooting
CNS
Problems Causes Solutions
The machine does not turn on. The machine is not connected to the
power source.
Connect the machine to the power source.
Contact Electrolux customer service.
The pump is very noisy. Both indicator
lights for small and big cups are flash-
ing. No water flow.
No water in the tank. Fill the tank with fresh drinking water.
1. Prime the water circuit.
2. Check correct water tank position.
The loading lever doesn’t reach the
brewing position.
Capsule inserted incorrectly. Empty the used capsule compartment.
Repeat the sequence, open and close the lever. If
that is not enough remove the capsule manu-
ally from the compartment after unplugging the
machine.
The coee is cold. Preheat the cup with hot water.
The coee is brewed too fast, the
brewed coee is not creamy.
Capsule already used. Open the lever and insert a new capsule.
Coee is not brewed or brewed in
drips only.
Coee spout is clogged Clean the coee spout.
Circuit is not primed Prime the water circuit.
Hot water / steam is not dispensed. Hot water / steam spout is clogged. Clean the steam spout with a needle (the machine
needs to be unplugged and the steam / hot water
knob needs to be closed).
The milk does not froth. Not suitable milk. Use fresh, partially skimmed milk.
The milk is too hot. Use milk at refrigerator temperature.
The hot water / steam spout is clogged. Clean the steam spout with a needle (the machine
needs to be unplugged and the steam / hot water
knob needs to be closed).
The machine requires a lot of time to
heat up.
The machine has limescale build up. Descale the machine.

8
Components
Milk Frother EMS5010
A. Pitcher
B. Start button with indicator
light
C. Release button
D. Handle
E. Lid
F. Sealing ring
G. Mixer rod
H. Whisk
I. Base station with cable
housing
J. Power cord and plug
EN
A
B
C
D
J
E
F
G
H
I
EN

9
Safety advice
Read the following instruction
carefully before using the appliance for
the first time.
• This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
•Children should be supervised to
ensure that they do not play with the
appliance.
•The appliance may only be connected
to a power supply whose voltage
and frequency comply with the
specifications on the rating plate!
•Never use or pick up the appliance if
– the supply cord is damaged,
– the housing is damaged.
•The appliance must only be connected
to an earthed socket. If necessary an
extension cable suitable for 10 A can
be used.
•If the appliance or the supply cord
is damaged, it must be replaced by
the manufacturer, its service agent or
similarly qualified person, in order to
avoid hazard.
•Always place the appliance on a
level surface.
•The appliance must be switched
and the mains plug withdrawn before
cleaning and maintenance.
• Pull the power plug from the outlet
before cleaning.
•Always allow the device to cool down
before cleaning.
•The pitcher has a non-stick coating on
the inside. Do not use any aggressive
or abrasive cleaning agents and no
solvents.
•Do not scrape tough soiling with
hard objects.
•Never submerge the device base, the
pitcher, the lid, the power cable or the
power plug into water or other liquids.
•Do not clean the device or parts of it
with the dishwasher.
•Appliance is for indoor use only.
•This appliance is intended for
domestic use only. The manufacturer
cannot accept any liability for possible
damage caused by improper or
incorrect use.
EN
IT

10
EN 1. Before first use, be sure to clean
all parts thoroughly. Note! The
2. To open the lid, push the release
button and remove the lid.
3. To close the lid, position the lid by the
spout side first, then press firmly the
rear part until it clicks.
Getting Started
Coee recipes
1. Froth the milk as described, with
the whisk. We recommend to ll in
the minimum level for 1 cappuccino
and the maximum level for 2. Prepare
an espresso in a cappuccino cup, and
then fill the cup with the frothed milk.
1. Heat the milk as desribed, without
the whisk. Pour the milk into a latte
glass. Place the glass under the coee
spout and prepare an espresso.
Cappuccino Cae Latte
pitcher can be washed under the
tap, but it is not dishwasher safe
and should not be immersed into
the water.