Electrolux Create 3 EVSK1 User manual

ProductOverview:
1. 1x Vacuum Pump
2. 10x Reusable Vacuum bags (23x26cm)
3. 1x Charger
1
3
2
AUTO
STOP
START
Create 3
Vacuum Starter Kit
Model: EVSK1
E-EVSK1-02-01-1220
electrolux.com
electrolux.com/shop
electrolux.com/support
Compatibility:
Vacuum Pump
EVSK1, EVFK1, EVFK1+
Create Vacuum Sealer
E4VS1-4AG*
Explore Vacuum Sealer
E6VS1-6AG
Vacuum Sealer with accessory hose adaptor

Battery is low Fully charged
Please
recycle
Ready to start :
Storage
Store in fridge or freezer.
Working temperature
-20º to 100º C.
Vacuum sealing complete :Vacuum sealing in operation :
Pulse
Press vacuum button.
Charging in process
1.5sec
x3
Max
100°C

The pump stops during the
vacuum sealing process
and does not turn back on.
The pump does not create
vacuum when placed on a
container or the vacuum
does not last.
The pump sucked in powder or
direct liquids during the vacuum
sealing process.
The lid of the vacuum container,
the silicone seal or the valve are
positioned incorrectly.
Do not turn the pump upside down. Remove the lower part and
clean to ensure that nothing is in their. Make sure the pump are
completely dry before operating again. Additional liquids may
drip out. Repeat this process if the pump stops again.
Check that the positioning is correct and that the lid is
properly closed.
The above problems cannot
be solved.
The vacuum pump could be broken. Contact customer service. Do not try to repair the pump
yourself.
The battery of the pump is low or
not charged.
Recharge the vacuum pump.
The silicone seal or the container v
alve are dirty or wet.
Clean and dry the silicone seal and the valve of the container.
The pump sits too loosely on the
valve.
During vacuum sealing, lightly press the pump into the dock
surrounding the valve to create a tight seal between the pump
and the valve.
Troubleshooting
Problem Possible cause Remedy