Elkay A55483 User manual

A55483 (Rev. B - 9/10)
Page 1
Installation Instructions for Wall
Mount and Deck Mount Faucets
ELKAY .2222 CAMDEN COURT . OAK BROOK, IL. 60523 USA

A55483 (Rev. B - 9/10)
Page 2
WALL MOUNT ASSEMBLY
Figure 1
Figure 2
General Instructions
 Turn off the water supply at the main source.
 Hand tighten all parts prior to tightening with
wrench. Do not force parts together.
 Handle plated surfaces with care, being careful
not to scratch with tools.
 Wall mount faucets have a ½” I.P.S. female
flanged inlet.
 For easier assembly, you may purchase as an
accessory, the LKMK462 mounting kit (see
Figure 2).
Assemble Faucet to Backsplash
1. Apply teflon tape or pipe joint compound to
supply line nipples.
2. Place nipples through holes in backsplash.
3. Assemble each flanged inlet to one nipple, then
the other.
4. Using the optional LKMK462, apply in order
behind the back-splash: rubber washer, washer,
lock nut and elbow (see Figure 2).
5. Thread flanged inlet loosely against wall or
backsplash.
6. Carefully orient, mount and hand tighten the
faucet to the two flanges. Besure to include the
washers provided.
7. Use wrench to tighten flange against
backsplash. (Maintain alignment of faucet or
spout to sink while tightening).
8. Wrench tighten flanges to faucet body.
9. Make sure drain is attached and turn on water
supply - being sure to check for leaks. Wrench
tighten where needed.
FaucetBody
Wall/Backsplash
Escutcheon
2” Offset
1/2” IPS
SupplyLine
Nipple
FaucetBody
1/2” IPS by 1/2”
Copper Sweat Elbow
Rubber
Washer
Lock
Washer
Nipple
1/2” Offset
Flanged Inlet
Lock Nut
Sink/Backsplash

A55483 (Rev. B - 9/10)
Page 3
DECK MOUNT ASSEMBLY
Figure 3
Shank
TO FIX SPOUT IN POSITION
1. Prior to spout installation, remove provided lock pin from sealed bag.
2. Place lock pin in the pierced hole at the base of the spout.
3. Align pin with slots in the ring found inside the throat of the spout connection on the faucet body.
4. Tighten spout nut to appropriate torque.
General Instructions
Turn off the water supply at the main source.
Hand tighten all parts prior to tightening with wrench. Do not force parts together.
Handle plated surfaces with care, being careful not to scratch with tools.
All deck mount faucets and spouts come complete with compression nut and one piece nutwasher
for ½” O.D. tube.
Assemble Base to Sink Deck
1. Apply Teflon tape or pipe joint compound to the
threads on the shank(s).
2. Place shank(s) through holes in deck.
3. Apply in order: nutwasher and nut (see Figure 3).
4. Hand tighten nutwasher against deck of sink.
(Maintain alignment of faucet or spout to sink while
tightening.
5. Attach supply lines.
6. Make sure drain is attached and turn on water
supply – being sure to check for leaks. Tighten
with wrench where needed.
Sink Deck
Nut
Nutwasher
FaucetBody
Gasket
FaucetBody

A55483 (Rev. B - 9/10)
Page 4
IMPORTANT END USER INFORMATION
Care and Cleaning Instructions
Your Elkay faucet has been constructed of the finest materials. However, certain
precautions must be taken to maintain the lustrous decorative finish.
Do not use abrasive cleaners or harsh chemical cleansers on this product which could
damage the finish.
A warm water wash with a wipedown using a soft cloth will generally remove dry water
spots. Never use alcohol or other organic solvents.
COMMERCIAL SINKS AND FAUCETS LIMITED WARRANTY
Elkay warrants commercial sink and faucet products to be free of defects in workmanship
and materials for a period of 5 years from the date of purchase. This warranty does not
cover transportation or installation charges. Contact Elkay customer service (630-572-
3192) for complete details and conditions.
TO OBTAIN SERVICE UNDER WARRANTY
1. Write to: Elkay
Attention: Consumer Service
2222 Camden Court
Oak Brook, Illinois 60523
2. Include a letter containing the following information:
a. Date of purchase and installation
b. Description of nature of defect.
c. Model number or description of model and/or component part if possible.
Elkay
www.elkayusa.com 2222 Camden Court Oak Brook, Il. 60523
USA
Printed in U.S.A.
© 2010 Elkay