Elkay LZ Series User manual

To reset the lter count on original EZH2O bottle lling stations like the one above,
you will rst need to access the control board toggle switch.
To do this, you will need to rst open the top of the bottle ller by removing the
two screws on the top. They are hex type (non-security), so you will need
a 5/32 Allen wrench.
UH-OH...
You’ve changed the lter,
but the light is still red!
COMMERCIAL RESTROOM ACCESSORIES
Distributed By
WWW.RESTROOMDIRECT.COM
704•937•2673
129 Oak Park Dr., Unit A,
Mooresville, NC 28115

Once you get the top o, it will look like
this. The toggle switch is here
and can be pressed down from
above or pushed (gently) forward
to “click” it. You can try this now
without eect.
Now press and hold the toggle switch
for two to three seconds and then
as soon as you notice the LCD
display brighten and switch
text, LET GO OF THE TOGGLE.
Your display will then cycle between
“SETTINGS”
and
“RST FLTR”
After 3
cycles
it will
revert to the bottle counter. If it does this before you are ready, simply press and hold the toggle
switch for two to three seconds again (releasing when the display changes).
While cycling, when the display changes to “RST FLTR”, click the toggle switch. The LCD display
will change to show“FLTR =”.
Click the toggle switch one more time and the display will show “FLTR =0”
COMMERCIAL RESTROOM ACCESSORIES
Distributed By
WWW.RESTROOMDIRECT.COM
704•937•2673
129 Oak Park Dr., Unit A,
Mooresville, NC 28115
The lter monitor should now be reset and the
Green LED at the far left should be illuminated
indicating that the visual lter monitor has been reset.
Replace the top cover and screws
and you’re ready for a cool drink.