Elnec 70-0072 User manual

DIL40/TSOP40 ZIF-CS 12.4mm
(ord.no. 70-0072)
universal adapter, assigned for TSOP/VSOP devices up
to 40-pins (for example EP OMs, FLASHs)
operation (mechanical) life of ZIF socket - 25.000
actuations
made in Slovakia
Ord. no 70-0072
Socket ZIF TSOP40, ClamShell type
Bottom 2 rows, 2x 20 pins, sq are, 0.6x0.6mm, rows spacing
430mil
Class Universal
Subclass DIL/TSOP
Adapter manual
Insert adapter to the device programmer ZIF socket according to the picture placed near of it. If you have
some doubts about orientation of this adapter in device programmer ZIF socket, it is valid general rule, the
orientation of the text of title is the same as the text on the top of the device programmer.
Open the adapter ClamShell ZIF socket. Insert the device into it (place device on contacts). The right position
of the programmed device in adapter ZIF socket is show at picture near (mainly left above) the adapter ZIF
socket. If you use thisadapter for devices with less than 40 pins, then place device to the bottom edge of
adapter ClamShell ZIF socket. Upper contacts stay unconnected.
Visually check interconnection between device and adapter ClamShell ZIF socket. If everything looks OK, close
it and now, device is ready for programming.
Be careful, because the incorrect insertion of adapter to the device programmer ZIF socket or device to the
adapter ClamShell ZIF socket can damage the programmed device.
To take out the device, open adapter ClamShell ZIF socket and remove device from it.
When you finish work with adapter, remove it from the device programmer ZIF socket.
Do not directly touch the pins of the adapter and adapter ZIF socket, because dirt may cause errors during
programming of device.
For handling with the device we recommended to use a vacuum pick up tool.
If programming yields isn't 100% when using programming adapter or if some unreliability appears, try to
connect one 22nF-100nF multilayer capacitor (that meet the EIA X7 or Z5U specification) between leads of
adapter connected to pins VCC and GND pins of programmed chip.
Software note
If software version, you're using currently, doesn't contain support for this programming adapter, please
download the latest version of software - egular or OnDemand - from our web site.

Accepted package(s)
TSOP32
TSOP40