Elo TouchSystems 15A2 for wireless card User manual

Revision B
P/N E605258
821107900602
Caution:
Before attaching the Customer Display to your monitor, make sure that power to the monitor and computer is off.
Make sure a USB cable is connected to
the USB connector on unit.
Connect the other end of the USB cable
to a USB port in your computer.
Installing the Customer Display for 1729/17A2/15A2
2008 Tyco Electronics.
Note: For ESY17A2 and ESY15A2 touchcomputers, the software for the peripheral
is already installed on the touchcomputer. For the ET1729L touchmonitor, refer to
the following:
North America
Elo TouchSystem
301 Constitution Drive,
Menlo Park, CA 94025
www.elotouch.com
Europe
Tel [phone]
Fax [phone]
[email protected]
Asia-Pacific
Tel [phone]
Fax [phone]
www.tps.co.jp
Latin America
Tel [phone]
Fax [phone]
www.elotouch.com.ar
Elo Technical Support
:
www.elotouch.com/go/websupport
www.elotouch.com/go/contactsupport
Online self-help
Technical Support contacts in your region:

Insert the connector of the cable
accompanying the Customer
Display into the mating connector
on the accessory hub in the rear
of the unit.
Turn off power to the unit and computer.
Place the unit upright then turn on.
Turn unit upside down and take off the
back cover insert.
Place the Customer Display onto the rear
of the unit, along the unit’s top side.
Unsecure the Customer Display door
from the unit’s top side.
Secure the Customer Display to the
unit using two screws from the
Customer Display Kit.
3
4
5
6
Replace the back cover insert.
7
8
1
2