October 2018
2
Quick Start Guide
NOTICE
This guide provides basic guidelines for Rosemount™ 5600. It does not provide instructions for configuration,
diagnostics, maintenance, service, troubleshooting or intrinsically safe (I.S.) installations. Refer to the
Rosemount 5600 Reference Manual for more instruction.
The manual and this guide are also available electronically on Emerson.com/Rosemount.
Failure to follow safe installation and service guidelines could result in death or serious injury.
Make sure only qualified personnel perform installation or service.
Use the equipment only as specified in this QSG and the Reference Manual. Failure to do so may impair the
protection provided by the equipment.
Repair, for example substitution of components etc. may jeopardize safety and is under no circumstances
allowed.
Explosions could result in death or serious injury.
Verify that the operating environment of the transmitter is consistent with the appropriate hazardous
locations specifications.
In an explosion-proof/flameproof installation, do not remove the transmitter covers when power is applied
to the unit.
Before connecting a HART-based communicator in an explosive atmosphere, make sure the instruments in
the loop are installed in accordance with intrinsically safe or non-incendive field wiring practices.
Electrical shock can result in death or serious injury.
Avoid contact with the leads and terminals. High voltage that may be present on leads can cause electrical
shock.
Make sure the main power to the Rosemount 5600 transmitter is off and the lines to any other external
power source are disconnected or not powered while wiring the transmitter.
Process leaks may cause harm or result in death.
Install and tighten antenna and flanges before applying pressure.
To avoid process leaks, do not remove tank seal while tank is under pressure.
Contents
Mount the transmitter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Connect wiring and power up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Configure the transmitter. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Product certifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
