Emerson Cooper-atkins 4det-306 User manual

To take a forehead temperature:

Infrared Forehead Thermometer

(4DET-306) Quick Start Guide

Detailed instructions are included in the packaging

If the body temperature is below 100°F

(38.7°C) you will hear one short beep and a

happy face will appear on the display.

If the body temperature is above 100°F

(38.7°C) you will hear one long beep

followed by three short beeps and a sad

face will appear on the display.

Press the power button , wait for 2 beeps.

Aim the thermometer at the center of the

forehead about 1 inch (2-3 cm) from the skin

and press the start button .

START

1” (2-3cm)

Temperature Taking Hints and Tips

• All body site temperatures are not the same. The

temperature taken at different sites on the body will vary

significantly. A forehead (temporal) temperature, for

example, is usually 0.5°F (0.3°C) to 1.0°F (0.6°C) lower

than an oral temperature.

• Make certain the thermometer is in FOREHEAD MODE.

• Non-contact infrared thermometers measure surface

temperature. Hold the device approximately 1 inch (2-3

cm) from the center of the forehead to capture just the

forehead temperature and not the temperature of other

surrounding objects.

• Always hold the thermometer and the forehead steady

when taking a reading. Do not move the thermometer

until you hear the final beep.

• The device is designed to be used indoors. Users and the

thermometer should be in the same ambient temperature

for at least 10 minutes before taking a reading.

• The tested individual should be away from extreme

temperatures for at least 10 minutes before taking a

measurement. Recent exposure to hot or cold

temperatures will impact your reading.

• Do not take temperatures with this thermometer near

places that are very hot, such as fireplaces and stoves.

• Remove hair, sweat, oils, cosmetics or dirt from the

forehead before taking a measurement. Wait at least 10

minutes after washing the forehead area before taking a

reading. Remove hats and wait 10 minutes before taking a

reading. Bangs may cause higher readings.

• The tested individual should not drink, eat, or be

physically active before/while taking the measurement.

PRODUCT FEATURES

Fast reading (approx.1 second)

No probe covers needed

Beeps when reading is complete

Mercury free

Stores 10 readings

Automatic shut-off

Fast reading (approx.1 second)

Beeps when reading is complete

Distributed by Cooper-Atkins

Emerson Commercial & Residential Solutions

33 Reeds Gap Road | Middlefield, CT 06455

T+800-835-5011 | F+860-347-5135

www.cooper-atkins.com | 67-1793 | 0520

Manufactured by JoyTech Healthcare Co., Ltd.

No.365, Wuzhou Road,

Yuhang Economic Development Zone,

311100, Hangzhou, China

T +86-571-81957767

Made in China

• Temporal artery temperature changes faster than a

temperature taken rectally, orally or under the arm. A

difference of 1°F (.6°C) is normal. Body temperature can

change throughout the day.

• Consistently low temperature readings may be caused by a

dirty instrument window. Use an alcohol wipe or a cotton

swab moistened with alcohol (70% isopropyl) to clean the

instrument window and housing. Gently wipe and let air dry.

DO NOT use any other cleaning liquids or immerse the

thermometer in water. Wait 10 minutes after cleaning to

take a temperature. See manual for complete cleaning

instructions.

• It is helpful to know each individual’s normal temperature

when they are well. This is the best way to accurately

diagnose a fever. To determine normal temperature, take

multiple readings when healthy. Re-measure with a

standard digital thermometer for confirmation. This

thermometer displays an oral equivalent temperature

reading. Oral readings are approximately 0.9°F (0.5 °C)

lower than a rectal digital measurement.

• When comparing temperature taken with different

thermometers at different sites, it is important to start with

the most accurate oral temperature that can be achieved.

Fast read digital thermometers use a method called “peak

hold” that is often less accurate than a digital thermometer

that needs to be held in the mouth for 60 seconds or more.

It is best to correlate other types of temperature taking to a

baseline oral temperature taken with accurate oral

thermometers, (those without the “peak hold” function).

The contents of this Quick Start Guide are provided by the manufacturer and are not to be construed as warranties or guarantees, express or implied, regarding the products or services described

herein or their use or applicability. Responsibility for proper selection, use and maintenance of product remains solely with the purchaser and end-user.