Emerson Rosemount 1208 User manual

Quick Start Guide
00825-0300-7062, Rev AA
June 2022
Rosemount™ 1208 Level and Flow
Transmitter
Extendable mounting bracket

1 About this guide
This guide provides instructions for mounting the extendable bracket.
1.1 Safety messages
WARNING
Failure to follow safe installation and servicing guidelines could result in
death or serious injury.
Ensure only qualified personnel perform the installation.
1.2 Bracket hole pattern
Figure 1-1: Hole Pattern for Wall Mounting
Ø 0.28 (7)
2.44 (62)
3.23 (82)
Dimensions are in inches (millimeters).
Quick Start Guide June 2022
2 Extendable mounting bracket

2 Mount the extendable bracket
Procedure
1. Mount the bracket on the pipe/wall.
On pipe:
13 mm
or
On wall:
June 2022 Quick Start Guide
Quick Start Guide 3

2. Mount the extendable arm.
Do not fully tighten the screws at this stage.
T30
3. Install and hand tighten the transmitter.
Quick Start Guide June 2022
4 Extendable mounting bracket

4. Connect the M12 cable.
5. Ensure the adjustable holder is properly aligned.
T30
June 2022 Quick Start Guide
Quick Start Guide 5

6. Fold down the arm to a horizontal position.
7. Adjust the length of the arm as necessary. Then tighten the two
screws.
T30
Quick Start Guide June 2022
6 Extendable mounting bracket

8. Check that the bracket installation is level.
To raise or lower the arm, adjust the two level screws. Then tighten
the two nuts.
T30 10 mm
9. Tighten the two screws.
T30
June 2022 Quick Start Guide
Quick Start Guide 7

*00825-0300-7062*
Quick Start Guide
00825-0300-7062, Rev. AA
June 2022
For more information: Emerson.com
©2022 Emerson. All rights reserved.
Emerson Terms and Conditions of Sale are
available upon request. The Emerson logo
is a trademark and service mark of
Emerson Electric Co. Rosemount is a mark
of one of the Emerson family of
companies. All other marks are the
property of their respective owners.