Empire Comfort Systems KENSINGTON LKF-2 Quick start guide

Page 1
INSTALLATION INSTRUCTIONS
AND OWNER’S MANUAL
KENSINGTON FOREST
VENTED DECORATIVE
GAS LOG SET
MODEL
LKF-2
FOR USE ON BURNER MODELS:
BF(L,M,R)(2124,30)(MTN,RN)-1
LKF-2 LOGS SHOWN ON BF(L,M,R)30
WARNING
FIRE OR EXPLOSION HAZARD
If the information in this manual is not
followed exactly, a re or explosion may
result causing property damage, personal
injury or loss of life.
— Do not store or use gasoline or other
ammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do
not use any phone in your building.
• Leave the building immediately.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the re department.
— Installation and service must be
performed by a qualied installer,
service agency or the gas supplier.
INSTALLER:
Leave this manual with the appliance.
CONSUMER:
Retain this manual for future reference.
CONGRATULATIONS on the purchase of your
new DECORATIVE VENTED GAS LOG SET!
Your Decorative Gas Log Set is designed
and intended for installation in an approved,
existing, fully vented, wood-burning replace,
with a gas hook-up.
The log placement shown in this manual
replicates the set-up shown in the brochure
and provides a great ame pattern.
IMPORTANT! Read these instructions
carefully before installing or operating this
gas appliance. These instructions should be
left with the homeowner for future reference.
WARNING
If not installed, operated and maintained
in accordance with the manufacturer’s
instructions, this product could expose you
to substances in fuel or from fuel combustion
which can cause death or serious illness.
WARNING
This log set is to be installed only in a sol-
id-fuel burning replace with a working ue
constructed of non-combustible material.
The vent damper must also have a damper
clamp attached to it to keep the damper from
accidentally closing during operation.

39667-0-0518Page 2
LKF-2 LOG PLACEMENT - 2124

39667-0-0518 Page 3
LOG IDENTIFICATION
DESCRIPTION FRONT VIEW - BF(L,M,R)(2124,30) DESCRIPTION FRONT VIEW - BF(L,M,R)(2124,30)
(Log A) (Log I)
(Log B) (Log J)
(Log C) (Log K)
(Log D)
(Log E)
(Log F)
(Log G)
(Log H)
DESCRIPTION FRONT VIEW - BF(L,M,R)30
(Log L)
NOTE: Logs are not shown to scale.
NOTE: Logs may differ from those shown.

39667-0-0518Page 4
LKF-2 LOG PLACEMENT - 2124
TOP VIEW
FRONT VIEW
1. Place Fiber Heat Sink (included with burner) onto top rear log support.

39667-0-0518 Page 5
LKF-2 LOG PLACEMENT - 2124
2. Place Log (A) onto top right side of Fiber Heat Sink.
TOP VIEW
FRONT VIEW

39667-0-0518Page 6
LKF-2 LOG PLACEMENT - 2124
3. Place Log (B) onto top left side of Fiber Heat Sink, and against top left side of Log (A).
TOP VIEW
FRONT VIEW

39667-0-0518 Page 7
LKF-2 LOG PLACEMENT - 2124
4. Place Log (C) onto front left side of burner pan.
TOP VIEW
FRONT VIEW

39667-0-0518Page 8
LKF-2 LOG PLACEMENT - 2124
5. Place Log (D) onto top right side of grill grate, and left side of Log (C).
TOP VIEW
FRONT VIEW

39667-0-0518 Page 9
LKF-2 LOG PLACEMENT - 2124
6. Place Log (E) onto top left side of grill grate, and against right end of Log (D).
TOP VIEW
FRONT VIEW

39667-0-0518Page 10
TOP VIEW
FRONT VIEW
LKF-2 LOG PLACEMENT - 2124
7. Place Log (F) onto front right side of burner pan.

39667-0-0518 Page 11
LKF-2 LOG PLACEMENT - 2124
8. Place Log (G) onto right side of Log (D), and against front right side of Log (A).
TOP VIEW
FRONT VIEW

39667-0-0518Page 12
LKF-2 LOG PLACEMENT - 2124
9. Place Log (H) onto top left side of grill grate, and below bottom left side of Log (E).
TOP VIEW
FRONT VIEW

39667-0-0518 Page 13
TOP VIEW
FRONT VIEW
LKF-2 LOG PLACEMENT - 2124
10. Place Log (I) onto left side of burner pan, and against left side of Log (H).

39667-0-0518Page 14
LKF-2 LOG PLACEMENT - 2124
11. Place Log (J) onto top of Log (I), and against top left end of Log (B).
TOP VIEW
FRONT VIEW

39667-0-0518 Page 15
TOP VIEW
FRONT VIEW
LKF-2 LOG PLACEMENT - 2124
12. Place Log (K) onto the top of Log (A), and against the top left end of Log (D).

39667-0-0518Page 16
LKF-2 LOG PLACEMENT - 2124
13. Log placement is complete.
FRONT VIEW
TOP VIEW

39667-0-0518 Page 17
LKF-2 LOG PLACEMENT - 30

39667-0-0518Page 18
LKF-2 LOG PLACEMENT - 30
1. Place Fiber Heat Sink (included with burner) onto top rear log support.
TOP VIEW
FRONT VIEW

39667-0-0518 Page 19
LKF-2 LOG PLACEMENT - 30
2. Place Log (A) onto top right side of Fiber Heat Sink.
TOP VIEW
FRONT VIEW

39667-0-0518Page 20
LKF-2 LOG PLACEMENT - 30
3. Place Log (B) onto top left side of Fiber Heat Sink, and against top left end of Log (A).
TOP VIEW
FRONT VIEW