The device is a powerful, high-performance Gigabit Ethernet switch,
with all ports capable of 10, 100 or 1000Mbps auto-negotiation
operation (NWay), which meansthe switch couldautomatically
negotiate with the connected partners on the network speed and
duplex mode. It is ideal for micro-segmenting large networks into
smaller, connected subnets for improved performance, enabling the
bandwidth demanding multimedia and imaging applications. Moreover,
the 10/100/1000Mbps auto-sensing ability provides an easy way to
migrate 10/100Mbps to 1000Mbps network with no pain. Compared to
the shared 10Mbpsor 100Mbps networks, the switch delivers a
dedicated 10/100/1000Mbps connection toevery attached client with
no bandwidth congestion issue. This switch also supports auto MDI /
MDI-X function. Each port could be used to connect to another switch
or hub with no crossover RJ-45 cable.
Store-and-forward switching mode promises the low latency plus
eliminates all thenetwork errors, including runt and CRC error packets.
To work under full-duplex mode, transmission and reception of the
frames can occur simultaneously without causing collisions as well as
double the network bandwidth.
The switch provides 9Kbytes jumbo frames, which means the frames
size is larger thannormal 1.5K. With the Jumbo frame function, you can
get better network performance, because the switch can send more
data at the same time with lower CPU usage.
The switch is plug-n-play without any software to configure and also
fully compliant with all kinds of network protocols.
Before you start to install the switch, check the following contents in this
package：
zOne Gigabit Ethernet switch
zOne external power adapter
zScrews and wall-mount plastic
zUser’s manual
2
