Encore ENDSL-AR User manual

Encore Electronics 2005
ENDSL-AR 1
ADSL Modem + 1 Port Router
ENDSL-AR
The ENDSL-AR is an ADSL modem with 1 Ethernet port and one USB 2.0
port. It features “always-on” capabilities and enables high-speed broadband
connection from a DSL line to any devices connected to the Ethernet port. The
ENDSL-AR4 ensures not only maximum performance, but also significantly
simpler handling process. Access the Internet, E-mail, and FTP simultaneously
from the LAN with a single DSL line. It can also provide one-to-one Ethernet
connection to any PC either by USB (Version 2.0)
This ADSL Ethernet Router is fully compliant with ANSI T1.413 Issue 2,
ITU-T G.dmt, ITU-T G.lite standards. Using existing twisted-pair telephone lines,
ADSL technology provides data rate more than 100 times faster than a traditional
analog modem without interruption of telephone service.
In addition, the ENDSL-AR provides a friendly configuration interface that
aims for easy installation for SOHO and residential users. Its internal country
settings will allow the router to function with ease in other countries. This product
is made to comply with the ISO9001 industry standard; it also complies with FCC
part15 and CE regulations.
Figure 1 Rear View

Encore Electronics 2005
ENDSL-AR 2
Figure 2 Usage Diagram
Figure 3 Web Interface

Encore Electronics 2005
ENDSL-AR 3
Product Specifications and Details
Supported ADSL Standards
•ANSI T1.413 issue 2
•ITU-T G.992.1 (G.dmt)
•ITU-T G.992.2 (G.lite)
•G.994.1 (G.hs, Multimode)
•ITU-T G.992.3 (ADSL2 G.dmt.bis)
•ITU-T G.992.4 (ADSL2 G.lite.bis)
•ITU-T G.992.5 (ADSL2+,Annex A, B, I, J, L
& M)
•Reach Extended ADSL (RE ADSL)
ATM Support
•Support up to 8 PVCs ATM Forum UNI
3.1/4.0 PVC Traffic Shaping UBR, CBR,
VBR-nrt
Multi Protocol over AAL5 (RFC1483 /
2684)
•Classical IP over ATM (RFC 1577)
•OAM F4 and F5 segment end-to-end
loopback, AIS, and RDI
•OAM cells
•VC and LLC Multiplexing
•VPI is 0-255 and VCI is 32-65535
•ATM SAR (Segmentation and
Reassembly)
•PPP over Ethernet (RFC 2516)
•PPP over ATM (RFC 2364)
•PPP over PAP (Password Authentication
Protocol; RFC1334)
•PPP over CHAP (Challenge Authentication
Protocol; RFC1994)
Bridging and Routing
•Ethernet to ADSL self-learning
•Transparent Bridging (IEEE 802.1D)
•IP routing-RIPv2 (backward compatible
with RIPv1)
•Routing (TCP/IP/UDP/ARP/ICMP)
•Static IP routing
•ICMP (Internet Control Message Protocol)
•IGMP (Internet Group Management
Protocol)
•IP Multicast IGMP v1/v2
•MIB II Support (RFC1213)
•PAT (Port Address Translation)
Security
•PAP (Password Authentication Protocol)
•CHAP (Challenge Authentication Protocol)
•User authentication for PPP
•Password Protected System Management
•VPN (IPSec, PPTP, L2TP) Pass-Through
HTTP Web-based management
•Firmware upgrade via FTP / TFTP (Web-
based)
•SNMP Support
•WAN and LAN connection statistics
•Selection of Bridge or Router Mode
•Configuration of VCs (Virtual Circuits)
•Configuration file backup and restore
Hardware Interface
•One USB port compliant with USB v1.1, full
speed (12Mbps)
•One RJ45 port compatible with IEEE
802.3/802.3u, 10/100Mbps auto selection
•One RJ11 port for ADSL connection
•One Power switch button for power on/off
•One reset button for restoration of factory
default setting
Support Operating Systems
•Windows 9X, ME, 2000, XP,Linux and
MAC
Power Requirement
•Power Adapter: Input 110+10 or 230+10
•VAC, Output 12VAC, 1000mA
Power Consumption: less than 10 Walt
Environmental
•Operating temperature: 0°C ~ 70°C
ambient
•Humidity: 5 % ~ 95 % (non condensing)
•Storage temperature:-40°C ~ 70°C

Encore Electronics 2005
ENDSL-AR 4
IP Management
•NAT (Network Address Translation)
•NAPT (Network Address and Port
Translation)
•DHCP Server/Relay/Client (WAN port)
•VPN (IPSec, PPTP, L2TP) Pass-Through
•DNS Proxy
•DDNS
•UPnP support
Certification
•FCC part 15, CE mark