Energenie ENER101 User manual

Instant Battery Power Check
Press the Smart button on the side briey and the level
of the internal battery of the charger will be dispayed
on the status LED lights. During the output charging,
press push button P/C to check battery power available
in the unit. This will be indicated by the 4 status lamps
which will illuminate for several seconds
Charging your mobile device
1. Connect your mobile device to the charger via the
USB cable and the correct connector for your device.
2. Initiate charging with a 2 second press of the Smart
button on the side of the unit. The red charging light
will illuminate indicating charging in progress.
3. When the mobile device is fully charged, charging
will terminate automatically and the red light will extin-
guish.
4. Charging can also be manually terminated at any
time by pressing the Smart button for 2 seconds.
Note 1: If the Smart button is pressed as above and no mobile
device is attached or the device is fully charged, the charger will
detect this and switch o charging after 30 seconds.
Note 2: If the charger battery level becomes low, the green LED
will ash continuously for 5 minutes and the charging process
will then terminate.
Note 3: In-built over-discharge protection prevents damage to
the internal battery of the charger
Out of the Box
Before the charger is used for the rst time, it
must be charged via a computer USB port or
similar for at least 2 hours.
USB
Phone Charger
F
L
IN
OUTLED
Power/Charge/LED
Features
USB output charger port
Solar or miniUSB input charging port
Fixed voltage constant current charging
LED Torch: normal, bright, ashing, SOS
LED status display: charging, discharging, battery
level, low battery.
Torch
1. The LED torch is operated by pressing the smart
button for longer than 2 seconds.
2. The display will cycle through 4 display modes
with each successive short button press:
normal -> bright -> ashing -> SOS
3. Holding the button down will turn the torch o.
Charging via sunshine and USB
The internal Lithium ion battery is charged either from
the sun or via its mini USB port.
a. Place directly under strong sunlight. A green light
indicates solar charging.
b. Connect the charger using the USB cable supplied
via the MiniUSB port of the charger to a laptop, PC, car
charger or other USB source. Charging will start auto-
matically.
Instant battery level will be shown on the four status
lights. When all four lights stay on without ashing, the
battery is fully charged.
During charging of the charger itself, the button is
inhibited from use.
Note: Over-charge protection prevents damage to the internal
battery.
1
2
3
4 5 6
INOUT
LED
F
L
100% Full
75%
50%
25%
Solar charging
Charging
1. Solar panel
2. Smart button
3. Status lights
4. MiniUSB port (in)
5. USB port (out)
6. LED torch light
Car charger
AC adaptor

User Guide for
Solargenie Mini Charger
Regulatory Information
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be deter-
mined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
• Consult the dealer or an experienced technician
for help.
• Changes or modications to this unit not expressly
approved by the party responsible for compliance will
void the user's authority to operate the product.
Energenie is a trading name of Sandal plc, Claremont House,
Deans Court, Bicester, UK, OX26 6BW
If you have questions, please visit us at
www.energenie4u.co.uk
Model: ENER101
Storage
For extended periods of non-use charge to about 50%
and store in a cool place ideally between 4ºC and 27ºC.
Lithium batteries continue to slowly discharge (self-
discharge) when not in use or while in storage. Check
the charge status of an unused unit every 6 months to
ensure at-least one lamp of charge charge is indicated.
Re-charge if necessary.
Specications
Solar Panel : 0.3W 5.5V 650mA
Battery : Rechargeable LIPO, 1200mAh
Cahrgeing cycles: After more than1000 charging cycles
power level may drop to 80%
Input : 5V, 500mA, MiniUSB connector
Output : 5V, 650-750mA, USB connector
USB charging time (90%): 0-70 mins
USB discharging time: 0-50 mins
Operating environment: -20 °C to +50 °C
Storage environment : -20 °C to +55 °C (ideally
between 4ºC and 27ºC to optimise battery life)
Weight: 52g
Protection: Short circuit, over-charge, over-discharge *
* When the battery level is very low, the protection
mechanism will operate and discharge and the LED
display will be disabled.
WEEE
This product is classed as Electrical or Electronic equip-
ment and comes under the WEEE waste disposal and
recycling requirements of Directives 2002/96/EC and
2003/108/EC within the EU. Please ensure that you
dispose of this product responsibly using your local
authority’s recycling facilities or via your supplier for
commercial customers.
140130