Eneroid EN10A2 User manual

EN10A2ㅣEN10A2
SMART BATTERY CHARGER & STORAGE
Important Safety Instructions
User's Manual

1. Do not use the charger in humid conditions.
2. Do not use the charger if it has a damaged plug.
3. Do not use the charger after it has been dropped or damaged.
4. Do not open/disassemble the charger.
5. Unplug the charger before maintenance or cleaning.
6. Do not use the charger in direct sunlight.
This appliance is not intended for use by persons(including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person reponsible for their safty.
Children should be supervised to ensure that they do not play with the appliance.
Important Safety Instructions
Care and cleaning is essential.
Unplug charger from AC outlet.
If necessary clean with a dry cl oth to remove dirt and grime.
Never immerse the charger in water or in any other liquid.
TEMPERATURE RANGE :
MAINTENANCE, CARE AND CLEANING :
Design by Seculine.
Made in Korea.
Seculine hereby declares that this product is in compliance with the essential requirments and
other relevant provisions of EU directive requirment. The complete declaration or conformity
can be found at www.eneroid.com
This manual contains important safty and operating instructions for eneroid battery
charger. Before Using, please read all of instructions.
Thank you for purchasing ENEROID.
Operating : -20℃~45℃
Charging : 5℃~40℃

Model
Compatibility
Dimensions
Weight
Input Power
Standby Capacity
Strorage Capacity
Color
EN10A2
AA battery (Ni-MH, Ni-CD)
11.5 x 12.5 x18 cm
650 g
USB-C type, 5V 2A
12 ea
21 ea
Body : White / Ring : Blue
EN10A3
AAA battery (Ni-MH, Ni-CD)
11.5 x 12.5 x18 cm
650 g
USB-C type, 5V 2A
15 ea
27 ea
Body : White / Ring : Green
Specfications
Charging Time
* Alkaline batteries have different charging times depending on their status and capacity.
Battery
AA 1000mAh
AA 2000mAh
AA 3000mAh
AAA 300mAh
AAA 500mAh
AAA 800mAh
EN10A2
About 1~1.5 hrs
About 2~3 hrs
About 3.5~5 hrs
-
-
-
EN10A3
-
-
-
About 1~1.5 hrs
About 2~3 hrs
About 3.5~5 hrs

Package Contents
Eneroid Body
User ManualUSB C-Type Cable

Names of Each Part
C-Type DC in
Stand-by room cover
Operation button
Error indication ring
Stand-by room
Battery Storage
Charged Battery Storage
Bad Battery Storage

1
Connect the C-Type cable supplied at the back of the
Eneroid. Press the power button briefly to enter
standby mode (power button blue LED lights up).
Connecting power

2
Regardless of the direction of the battery terminal,
ENEROID is able to recognize the terminals and
charge up the batteries automatically.
Any Polarity Direction

3
Close the cover and press the power button in
standby mode to start charging. While charging, the
red LED on the Eneroid's power button blinks.
Charging the Batteries

4
When charging is complete, the unit enters standby
mode. Open the locker and use a charged battery on
the right side of the locker. Discard the batteries in
the defective battery compartment on the left side
of the cabinet as they can no longer be reused.
Using the battery
Bad Charged

While in sleep mode or charging, press
the power button briefly to switch to
standby mode. When in standby
mode, the blue LED on the power
button turns on. If you do not use your
computer for a certain period of time,
it goes to sleep (power button LED
off).
If you press and hold the power button for
3 seconds in standby mode, all the
batteries in the standby part and the
charging part are discharged to the fully
charged storage box.
Sleep mode
Manual battery drain

Error
The LED will light up at the top of the ring when the battery is
hanging or there is no battery to charge. Open the cover and
check if the battery is present.
No battery in the stand-by room
When the compartment is full of batteries and can no longer be
ejected, the LED on the bottom of the ring lights up. Open the
locker and collect the battery before use.
Full Battery Storage
When there is a malfunction or unknown problem, the LEDs
light up at the top of the ring. Please contact the service center.
Other errors
You can handle the error situation
intuitively with the LED lighting of the
ring. When the LED above the ring lights
up, open the cover and check the waiting
area. When the LED below the ring lights
up, open the storage box and check if the
battery is full.

ⓒ2016 Eneroid. All rights reserved. Eneroid, the Eneroid logo, and other Eneroid marks are owned
by Eneroid and may be registered. All other trademarks are property of their respective owners.
Eneroid assumes no responsibility for any errors that may appear in this manual. Information
contained herein is subject to change without notice.
www.eneroid.com
SMART BATTERY CHARGER & STORAGE