Skyrc eN18 NiMH User manual

Instruction Manual
SK - 100184
eN18 NiMH Battery Charger
V1.0
INTRODUCTION
Congratulations on your choice of SkyRC eN18 charger.
eN18 is an easy-operation charger for 4-8S NiMH battery. It will start charging
once you insert the battery. Please read the instructions carefully before using.
LED STATUS EXPLANATION
USING THE CHARGER
SPECIFICATION
Bi-Color LED: status at a glance
Reverse polarity protection
Easy operation: universal-voltage input
Short circuit protection
LED Status
Flashes GREEN
Steady GREEN
Charging Status
Charging
Fully charged
Input: AC100V-240V 50/60Hz
Battery Type: NiMH
Output Voltage: 4.8V-14.4V
Output Current: 1.2A
Output Power: 18W Max.
Battery Cell: 4-8S
Output Cable Length: 70cm
Size: 85mm×50mm×54mm
FEATURES
OUTPUT CONNECTOR*
Net Weight: 120g
Operating Temperature: 0℃-40℃
（32℉-104℉）
Relative Humidity: 5%-75%
Storage Temperature: -10℃ - 70℃
（14°F-158°F）
Storage Humidity: 5%-75%
LED Status
Steady RED
Flashes RED*
Charging Status
Standby
Error
If the LED flashes RED, it should be that the battery is connected reversely,
over-discharged, or could not reach the specified voltage, or the battery
cells are not applicable. If you doubt that the connection is reversed,
please remove the battery immediately and check the battery polarity.
*
*Please disconnect the battery and the AC power source when fully charged.
Status
Indicator
NI-MH Battery
or Tamiya Male
Deans Male
Optional Parts
Deans Female
to Tamiya Male
SK-600023-17
Tamiya Female
to Mini Tamiya Male
SK-600023-18
LED stays in steady RED
Standby LED flashes GREEN
Charging
*The specific input converter
type refers to the actual SKU
description.
DO NOT attempt to charge LiPo batteries.
IT WILL CAUSE FIRES!
1. Connect the charger to the wall socket. The LED will be steady RED, reflecting
it is on standby.
2. Connect the battery; the charger will start charging automatically with LED
flashing in GREEN.
3. When fully charged, the LED will stay in steady GREEN.
The charging cables is not included in
the package. You need to purchase
them separately.
* The specific connector
refers o the actual SKU
description.
Detachable
Input Converter

LIABILITY EXCLUSION
This charger is designed and approved exclusively for use with the types of the
battery stated in this Instruction Manual. SkyRC accepts no liability of any kind if
the charger is used for any purpose other than that stated. We are unable to
ensure that you follow the instructions supplied with the charger, and we have no
control over the methods you employ for using, operating and maintaining the
device. For this reason we are obliged to deny all liability for loss, damage or costs
which are incurred due to the incompetent or incorrect use and operation of our
products, or which are connected with such operation in any way. Unless other-
wise prescribed by law, our obligation to pay compensation, regardless of the legal
argument employed, is limited to the invoice value of those SkyRC products that
were immediately and directly involved in the event in which the damage occurred.
We guarantee this product to be free of manufacturing and assembly defects for
one year from the time of purchase. The warranty only applies to material or
operational defects, which are present at the time of purchase. During that period,
we will repair or replace free of service charge for products deemed defective due
to those causes. This warranty is not valid for any damage or subsequent damage
arising as a result of misuse, modification, or as a result of failure to observe the
procedures outlined in this manual.
The warranty service is valid in China only.
If you need warranty service overseas, please contact your dealer in the first
instance, who is responsible for processing guarantee claims overseas. Due to
high shipping cost, complicated custom clearance procedures to send back to
China. Please understand SkyRC can't provide warranty service to overseas end
users directly. If you have any questions which are not mentioned in the manual,
please feel free to send email to [e-mail]
The eN18 satisfies all relevant and mandatory CE directives and FCC Part
15 Subpart B.
The product has been tested to meet the following technical standards:
This symbol means that you must dispose of electrical from the general
household waste when it reaches the end of its useful life. Take your charger
to your local waste collection point or recycling center. This applies to all
countries of the European Union, and other European countries with a
separate waste collection system.
Please read this instruction manual carefully for maximum safety.
The battery and charger will be hot during charging, so please use the charger
in a well-ventilated area.
DO NOT leave the charger and battery unattended while charging.
DO NOT attempt to charge If battery pack is damaged in any way.
If you find any malfunction, please terminate the process at once.
Protect the charger from heat, damp, water and direct sunshine.
Keep the charger away from children.
Note:
CAUTION
WARRANTY AND SERVICE
2021.09
Made in China
7504-1546-01
Test Standards Title
CE-LVD EN 60335-
1:2012+A11:2014 Conform
Result
Household and similar electrical appliances -
Safety - Part 1: General requirements
EN 60335-2-29 Conform
Household and similar electrical appliances –
Safety – Part 2-29: Particular requirements
for battery chargers.
CE-EMC
FCC-SDOC
EN 55014-1:2017
Electromagnetic compatibility –
Requirements for household appliances,
electric tools and similar apparatus - Part 1:
Emission
EN 55014-2:2015
Electromagnetic compatibility –
Requirements for household appliances,
electric tools and similar apparatus – Part 2:
Immunity Product Family Standard
EN 61000-
3-2:2019
Electromagnetic compatibility (EMC) – Part
3-2: – Limits for harmonic current emissions
(equipment input current up to and including
16 A per phase)
EN 61000-3-3:
2013+A1:2019
FCC Part
Subpart 15B
Electromagnetic compatibility (EMC) - Part
3-3: Limitation of voltage supply systems for
equipment with rated current ≤16 A.
Title 47 Telecommunication
PART 15 - RADIO FREQUENCY DEVICES
Subpart B - Unintentional Radiators
Conform
Conform
Conform
Conform
Conform
THIS AC CHARGER IS FOR USE WITH NIMH BATTERY PACKS ONLY.
TO PREVENT A FIRE RISK, DO NOT ATTEMPT TO CHARGE LIPO
BATTERIES OR ANY OTHER TYPE OF BATTERY.