ENGO CONTROLS ERM12A User manual

ERM12A connection
1. ERM12A 230V AC power supply
2. Volt free input
3. 230V AC input
4. NO/COM/NC volt free output
5. Blue LED indication of the relay status
ERM12A is used for switching on/o electrical devices. Thanks to its small
dimensions, it can be installed in an installation box or where there is a
need to control a receiver with a maximum load of 12A.
The relay must be powered by 230 V AC. Relay control is done by applying
voltage 230V AC to the input contact SL or by shorting the COM / NO input
contacts (VOLTAGE FREE INPUT). This will switch the contacts in the NO /
COM / NC output circuit. The relay operation status is indicated by a blue LED.
After 230 V AC voltage decay from the SL input or after opening the COM /
NO volt free input, relay module will return to its original position.
Use in accordance with national and EU regulations. Use the device only as
intended, keeping it in a dry condition. The product is for indoor use only.
Installation must be carried out by a qualied person in accordance with
national and EU regulations.
Before connecting the relay module with a dierent device make sure
that its parameters are consistent with the ERM12A module specication.
Incorrect connection may cause undesirable action, excessive overheating
and combustion hazard. To avert the hazard make sure that the relay
module ERM12A is correctly connected.The connection of the device can be
done only by a qualied installer who has up-to-date eligibility.
Technical specication
Introduction
Description of operation
Safety information
Product Compliance
Power supply 230V AC 50Hz
max. load 12A
input COM / NO volt free
SL 230V AC
output NO/COM/NC
Dimensions [mm] 48x48x20
This product complies with the following EU Directives: 2011/65/EU, 2014/30/EU.
www.engocontrols.com
1
2
3
4 5
Quick Guide
Ver. 1
Release date: IX 2022
Distributor:
QL CONTROLS Sp z o.o. Sp. k.
43-262 Kobielice
4 Rolna St.
Poland
Producer:
Engo Controls S.C.
43-200 Pszczyna
3E Górnośląska St.
Poland
ERM12A | Relay Module 12A
RELAY

Connection of a 230V AC voltage thermostat, e.g. ESIMPLE230W / B, to a boiler equipped with an ON / OFF voltage free input.
Connecting a battery thermostat (e.g. ENGO E901) with a COM / NO output (normally open contacts) to
solid fuel boiler controller that requires a COM / NC (normally closed) contact.
Connecting a 230V AC voltage thermostat or a battery thermostat with a COM / NO output to
an electrical device which requires greater power than is allowed by the thermostat’s built-in relay.
ATTENTION! The maximum power consumption of the electrical device must not exceed 12A.
Connection of the ENGO ECB08M230 wiring cetre’s zone with more than 6 thermoelectric actuators or other devices than
actuators (e.g. pumps, electric heating mats).
Controlled device power load is focused on the ERM12A relay rather than wiring centre’s zone relay.
ATTENTION! The maximum power consumption of the electrical device must not exceed 12A.
CONTROL BOX
WIRING DIAGRAM No1 WIRING DIAGRAM No3
WIRING DIAGRAM No2 WIRING DIAGRAMS No4