10. EG28 or EG40: Remove the 4” (10 cm) ue collar from the unit and remove any loose sealant.
Install the new Ø 4” (10 cm) by 5” (12.5 cm) ue collar provided in this kit.
Westport: Install the 4” (10 cm) adaptor into the exhaust outlet on the unit. Apply a bead of high
temperature silicone.
11. Attach the exible liner to the vent termination cap by placing a small bead of high temperature
silicone on the vent termination and slide the ex liner onto the vent terminal and secure with three
(3) sheet metal screws evenly spaced.
12. Dress the ex liner through the wall thimble and attach the vent
terminal to the outside of the house using four (4) wood screws
provided. The use of non-hardening mastic should be used around
the vent to ensure a watertight seal.
13. Install two (2) wire spacer around the ex pipe. Slide the horizontal
section of pipe over the exible liner. Ensure the wire spacers are
positioned at either end of the pipe (refer to Figure 2 and 3).
14. Install the horizontal section of pipe through the wall thimble,
ensure that this portion of pipe slides onto the vent termination
cap.
15. Slide the inside nished collar over the horizontal section of pipe
and secure to wall using the screw provided.
16. Slide the 90° elbow over the ex pipe. Do not slip the outer
sections of pipe together, you will require some movement
in these pipe section in order to secure the ex pipe to the
ue outlet on the appliance.
17. Stretch the ex liner to a length long enough to ensure the ex
liner can be easily connected to the ue outlet of the appliance.
18. Install the remaining wire spacers over the exible liner and install
the vertical section of pipe. Ensure the wire spacers are positioned
at either end of the pipe (refer to Figure 2 and 3).
19. Place a bead of high temperature silicone on the ue pipe and slide
the ex liner over the collar, secure the ex liner with three (3)
sheet metal screws evenly spaced.
Figure 2
Figure 3
20. Align all straight sections of pipe, slipping all joints
together and installing with three (3) sheet metal
screws evenly spaced.
21. Install the brass decorative rings around each joint
making sure this decorative ring covers the sheet metal
screws that secure each section of pipe together and
secure to vent pipe in the slotted tab on the backside of
the pipe so that the fastener would not be seen.
22. Secure the horizontal section of pipe to the inside
nished collar by installing a screw in the tab on the
inside nished collar. This will prevent the pipe from
being disconnected at the vent terminal.
23. Light the appliance and ensure proper operation.
