Epcom X67RB User manual

Operation and Maintenance
To be able to manipulate the equipment, it is necessary to connect
the harness of the lightbar with the harness of the X303 controller,
making sure they are correctly connected until a click is heard.
It is recommended to periodically check the mounting bolts to
avoid any accidents.
Use mild soap and a soft cloth to clean the plastic
covers.
Note: Do not use gasoline or other organic solvents to clean the
plastic cover, otherwise they will crack or become opaque.
Content
•Lightbar X67RB 1 Pz
•Controller X303 1 Pz
•Hook Mount 1 Pz
We are not responsible:
1) Hits or scratches during use.
2) If they use the wrong voltage.
3) By using a chemical to perform some maintenance
and / or cleaning of the equipment.
User Manual
Lightbar
X67RB

INTRODUCTION
Thank you for choosing our X67RB lightbar, which manages
70 Brilliant LED Gen III (Generation III); In order to meet your
needs and ensure excellent performance.
The X67RB lightbar, handles the highest LED technology, high
brightness, low power consumption and long service life.
Please read the manual before installing the X67RB lightbar, to
avoid damage due to improper use.
Technical Data
•Voltage: 12VDC
•Consumption: 12 A Max
•Temperature：-40～55°C
•Flash Patterns: 13
•Dimensions: 118cm x 34cm x 12cm
Power Supply Connnection
•Red Cable: VCC
•Black Cable: GND
Controller X303
Selector 1.- Has 4 positions:
1. Lightbar OFF
2. Turn on 1 red module and 1 blue module both from
the rear.
3. Turn on 1 red module and 1 blue module on the front;
2 red modules and 2 blue modules on the back.
4. They light 2 red modules and 2 blue modules on the front;
3 red modules and 3 blue modules on the back of the bar.
Switch 1.- Allows changing the type of lights pattern.
Switch 2.- It allows to light the left alleyway light.
Switch 3.- It allows to turn on the penetration lights.
Switch 4.- It allows to light the right alleyway light.
Selector 2.- This selector allows you to manipulate the Signal
master of the lightbar, it has 4 positions:
1. Turn OFF Signal Master
2. Addressing from right to left
3. Addressing from left to right
4. Addressing the center out