Epson PictureMate Snap PM 240 Instruction Manual

2Plug
1Connect the power
PictureMate.
2Connect the power
cable to the power
adapter.
3Plug the other end
of the power cable
into a power outlet.
4Flip the handle to
5Open the paper
6Press the On
After a moment, you
this on the photo
viewer screen:
Now you can install your
3Install
Photo
1Open the cartridge
*410693400*
*410693400*
Start Here
Follow these steps to set up your PictureMate®Snap
or Flash and print–no computer required!
Note: PictureMate Snap is shown throughout, but the steps are the
same for PictureMate Flash. To print from your computer, see the
Basics book and your CD after completing these steps.
1Unpack
PictureMate comes with all these items in the box.
1 Remove all the tape and packing material from the
outside of PictureMate.
2 Open the cartridge door
on the back of
PictureMate.
3 Remove the packing
material from inside the
cartridge slot.
4 Close the cartridge door.
PictureMate
Initial PictureMate
photo cartridge
PictureMate
photo paper
Basics book Printer Software CD
Power adapter Power cable
®
PictureMate Snap
(PM 240)
PictureMate Flash
(PM 280)

2Plug In and Turn On
1Connect the power adapter to the back of
PictureMate.
2Connect the power
cable to the power
adapter.
3Plug the other end
of the power cable
into a power outlet.
4Flip the handle to the back.
5Open the paper support.
6Press the On button to turn on PictureMate.
After a moment, you see
this on the photo
viewer screen:
Now you can install your initial photo cartridge.
3Install the Initial
Photo Cartridge
1Open the cartridge door.
PictureMate charges the print head for
3 to 4 minutes and displays the screen above.
7When you see the
Charging complete
message on the photo
viewer screen, press OK.
Turn over
Press here

Turn On
to the back of
back.
to turn on PictureMate.
see
photo cartridge.
Initial
2Slide the cartridge lever left
to the Release position.
3Remove the initial photo cartridge
from its package.
Caution: Do not install a
different PictureMate
cartridge for initial setup.
Install only the initial photo cartridge
that came with PictureMate.
4Slide the cartridge straight into the slot, label side up,
until it clicks into place. It will not go in all the way.
5Slide the lever all the way right, to the Lock position.
6Close the cartridge door.
PictureMate charges the print head for
3 to 4 minutes and displays the screen above.
7When you see the
Charging complete
message on the photo
viewer screen, press OK.
Turn over
Press here

4Load Paper
PictureMate comes with genuine Epson®glossy photo paper
made especially for printing lab quality photos.
Caution: Don’t load or print on plain paper; this may damage
PictureMate.
1Move the handle to the back
and open the paper support,
if necessary.
2Press the Open
button to open the
output tray.
3Slide the edge guides outward.
4Load up to 20 sheets at a time. Fan the sheets to
slightly separate them.
5 Place your paper into the slot between the edge
guides with the glossy side up. Slide the edge guides
inward slightly.
6 Raise the photo viewer screen.
Note: Keep unused paper in the original package and store it flat to
prevent curling.
Load glossy side up
Make sure paper
is beneath arrow
on edge guide

Select All Photos
1Press the Select All selection
button. (The selection
button is the
the photo
2To print more
the photos, press
the number.
selection button
3Press Proceed.
4To change the
photo, press
OK to increase
5Continue with
Print Selected
1Press the Print
button and use
your selected
2Press Layout to
of your photos
3Press Print
More on
Check your printed
See the Basics book for
printing from
and other devices. Also
photos to or print photos
replace your Print Pack
photo cartridge), take care
and solve problems.
Check your on-screen
After you install your
from the CD, you’ll see an
PictureMate User’s Guide
Double-click that icon for
on using PictureMate and
Note: For information on
go to
product under
in the Drivers & Downloads
Caution: To
it out of the sun
location where it
photo paper
may damage
the sheets to
the edge
the edge guides
and store it flat to
5Insert a Memory
Card
1 Remove the memory card containing photos from
your digital camera.
2Insert your memory card into the correct slot on
PictureMate.
3Push the card in until it stops (it won’t go in all the
way). The memory card light comes on and
PictureMate tells you how many photos are
on the card.
Note: Insert just one card at a time. PictureMate does
not read multiple cards at once.
6Print Your Photos
PictureMate’s photo viewer screen makes it easy to select the
photos you want to print.
Select Some Photos
1Press or to view your photos.
2Press OK to select a photo for printing.
3To print more than one copy,
press OK to increase the number.
Press the Copy - selection button
to decrease it. (The Copy -
selection button is the left button
beneath the photo viewer screen.)
4To select more photos, press
or to view the photo and
press OK to select it. Repeat step 3
to select more copies, if necessary.
5Continue with “Print Selected Photos” to the right.
Epson and PictureMate are
trademark of Seiko Epson
General Notice: Other product names used herein are for identification purposes
only and may be trademarks of their respective owners. Epson disclaims any and
all rights in those marks.
© 2006 Epson America, Inc. 7/06 CPD-22153
Printed in XXXXXX XX.XX-XX XXX
Microdrive™
CompactFlash®(Type I and II)
* Adapter required
** Maximum capacity 128MB
Bottom
Load glossy side up
Memory card light
SD™ (Secure Digital)
SDHC™ (High Capacity)
mini SD™ *
mini SDHC *
micro SD *
micro SDHC
MMC™ (MultiMediaCard™)
xD Picture Card™
xD Picture Card (Type M and Type H)
Sony Memory Stick® **
Memory Stick Duo™ *
Memory Stick PRO™
Memory Stick PRO Duo™ *
MagicGate™ Memory Stick **
MagicGate Memory Stick Duo™ *
Top

Select All Photos
1Press the Select All selection
button. (The Select All selection
button is the left button beneath
the photo viewer screen.)
2To print more than one copy of all
the photos, press OK to increase
the number. Press the Copy -
selection button to decrease it.
3Press Proceed.
4To change the number of copies of an individual
photo, press or to select the photo. Then press
OK to increase the number, or Copy -to decrease it.
5Continue with “Print Selected Photos” below.
Print Selected Photos
1Press the Print Preview selection
button and use or to review
your selected photos.
2Press Layout to select the layout
of your photos on the paper.
3Press Print to print your photos.
More on PictureMate
Check your printed manual
See the Basics book for instructions on
printing from PictureMate, your computer,
and other devices. Also learn how to save
photos to or print photos from a CD,
replace your Print Pack (photo paper and
photo cartridge), take care of PictureMate,
and solve problems.
Check your on-screen manual
After you install your PictureMate software
from the CD, you’ll see an icon for your on-screen
PictureMate User’s Guide on your computer screen.
Double-click that icon for comprehensive instructions
on using PictureMate and its software.
Note: For information on possible software updates for PictureMate,
go to http://support.epson.com, select Printers, and select your
product under Personal Photo Lab. Then check for updated software
in the Drivers & Downloads section.
Caution: To avoid damaging your PictureMate, keep
it out of the sun and don’t leave it in your car or other
location where it can get too hot or too cold.
photos from
slot on
go in all the
on and
are
does
to select the
more photos, press
view the photo and
to select it. Repeat step 3
more copies, if necessary.
with “Print Selected Photos” to the right.
Epson and PictureMate are registered trademarks and Exceed Your Vision is a
trademark of Seiko Epson Corporation.
General Notice: Other product names used herein are for identification purposes
only and may be trademarks of their respective owners. Epson disclaims any and
all rights in those marks.
© 2006 Epson America, Inc. 7/06 CPD-22153
Printed in XXXXXX XX.XX-XX XXX
®(Type I and II)
128MB
Digital)
Capacity)
(Type M and Type H)
Stick® **
Duo™ *
PRO™
PRO Duo™ *
Stick **
Stick Duo™ *