Epson PM-400 Setup guide

Choose 2Rent
Phone [phone]
Fax [phone]
[e-mail]
www.choose2rent.com
page 1 of 4
How to set up your Epson PM-400
1. Connect the power adapter to the side of the printer and connect the
power cord into an electrical outlet.

page 2 of 4
2. Unpack the ink cartridge and only remove the yellow tape, do not
remove any other labels or seals. (ink may leak)
3. Remove the cap and carefully dispose of it.
4. Do not touch the ink ports as it can prevent normal operation
5. Open the inner cover and hold the cartridge with the green chip facing
towards you. (Do not touch the flat white cable)
6. Insert the cartridge at an angle as shown and press the ink catridge
down until it clicks into place.

page 3 of 4
7. Close the cover and press the button to start charging the ink.
8. Slide the edge guide to the right, load your badge stock (25max) and
slide the edge guide back against the paper, but not too tightly.

page 4 of 4
9. Select Wi-Fi setup in the menu and press OK.
10. If your router supports WPS, select press the WPS button on the
router and then select WPS on the printer to allow it to search.
(Connection Established)
11. If your router does not support WPS, search for the router SSID in the
list and connect by entering the password.
Please note: Router must have 2.4GHz channel open in order for the printer to connect.
Trouble Shooting
My printer is printing faded, blurry, or with an outline no fill.
•Under the Maintenance Menu perform a nozzle check
oStraight lines signify nozzle is clean
oCrooked lines signify nozzle is clogged
•Perform a Head Cleaning (this uses ink to clean; use
1-2 times only)
My printer does not see my router SSID
•Check router configuration and be sure that 2.4GHz is enabled
Please call our support team if you need assistance
setting up your rental devices
1(800) 622-6484