Epson 1925W - POWERLITE Multimedia Projector Instruction Manual

INSTALLATIONHANDBOOK
Maintenance
Epson PowerLite 1925W
1
Air Filter and Vent Maintenance
The projector's air filter keeps the intake air clean, and its vents expel the exhaust. If dust collects on the
air filter or vents, clean them as described in this manual. Dust clogs may cause the projector to overheat
due to improper ventilation.
Be sure to clean the air filter and vents if you see a message telling you to do so. Also make sure nothing
blocks the vents.
Cleaning the Air Filter and Vents
Replacing the Air Filter
Cleaning the Air Filter and Vents
Be sure to clean the projector's air filter or vents if they get dusty, or if you see a message telling you to
clean them.
1. Turn off the projector and unplug the power cord.
2. Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as
a paintbrush).
Note: You can remove the air filter so you can clean both sides of it.
3. If dust is difficult to remove or the air filter is damaged, replace the air filter.
Replacing the Air Filter
You need to replace the air filter in the following situations:
•After cleaning the air filter, you see a message telling you to clean or replace it
•The air filter is torn or damaged
You can replace the air filter while the projector is mounted to the ceiling, if necessary. The illustrations
below show the projector placed on a table.
1. Turn off the projector and uplug the power cord.

INSTALLATIONHANDBOOK
Maintenance
Epson PowerLite 1925W
2
2. Open the air filter cover.
3. Pull the air filter out of the projector.
Note: Air filters contain polycarbonate, ABS resin, and polyurethane foam. Dispose of used air filters
according to local regulations.

INSTALLATIONHANDBOOK
Maintenance
Epson PowerLite 1925W
3
4. Place the new air filter in the projector as shown and push gently until it clicks into place.
5. Close the air filter cover.