Epson PowerLite 450W Operating manual

INSTALLATION HANDBOOK
Maintenance
Epson PowerLite 450W / 460
1
Cleaning the Air Filter
Your projector includes an air lter to ensure the best performance
and help protect your equipment investment. If dust collects on the
air lter, clean it as described here. Dust clogs prevent proper
ventilation and can cause overheating, which can damage the
projector.
1. Turn o the projector.
2. Remove dust from the air lter using a small vacuum cleaner
designed for computer or oce equipment, or gently clean the
vent with a soft brush (such as an artist’s paintbrush).
You can remove the air lter to clean both sides.
If the lter is too dirty or broken, replace the lter as described below.
Replacing the Air Filter
You need to replace the air lter if:
You cannot remove the dust from it
The air lter is damaged or torn
You repeatedly see a projected message telling you to clean or
replace it
note
To order replacement air
lters, request part number
V13H134A27.

INSTALLATION HANDBOOK
Maintenance
Epson PowerLite 450W / 460
2
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766) to obtain a new air lter. Request part number
V13H134A27.
1. Turn o the projector and unplug the power cord.
2. Slide the switch, then open the air lter cover on the side of the
projector.
3. Grasp the tab and pull the air lter straight out as shown.
note
Air lters contain
polycarbonate, ABS resin,
and polyurethane foam.
Dispose of used air lters
according to local
regulations.
4. Press in the new air lter until it clicks into place.