Epson PowerLite D6150 System manual

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite D6150 /
D6155W / D6250
1
Projector Light Status
The lights on the projector's control panel indicate the projector status and let you know when a problem
occurs. Check the status and color of the lights and look for a solution in the table here.
1 Power light
2 Lamp light
3 Temperature light
4 Filter light
Power light Lamp Temperature Filter light Status and solution
light light
Green Off Off Off Normal operation.
Flashing green Off Off Off Warming up. Wait for an image to appear.
Orange Off Off Off Standby or sleep mode.
Flashing orange Off Off Off Preparing network monitoring or shutting
down. (Wait for the light to remain orange
before unplugging the projector.)
Flashing red Off Flashing Off Projector is too hot.
orange •Make sure that the vents and air filter are
not clogged with dust or obstructed by
nearby objects.
•Make sure the environmental temperature
is not too hot.
•If overheating continues, replace the air
filter.

INSTALLATION HANDBOOK
Epson PowerLite D6150 /
D6155W / D6250 Lamp and Status Information
Red Off Red Off Projector has overheated and turned off.
Leave it turned off to cool down for five
minutes.
•Make sure that the vents and air filter are
not clogged with dust or obstructed by
nearby objects.
•If operating the projector at high altitude,
turn on High Altitude Mode.
•If overheating continues, replace the air
filter.
•If the problem persists, unplug the projector
and contact Epson for help.
Red Flashing Off Off Lamp has a problem.
red •Check to see if the lamp is burned out,
broken, or installed incorrectly. Reseat or
replace the lamp as necessary.
•Make sure that the vents and air filter are
not clogged with dust or obstructed by
nearby objects.
•If operating the projector at high altitude,
turn on High Altitude Mode.
•If the problem persists, unplug the projector
and contact Epson for help.
Power light Lamp Temperature Filter light Status and solution
light light
On Off Off Flashing It is time to clean the air filter.
green
On Off Off Flashing Low air flow through the projector.
orange •Make sure that the vents and air filter are
not clogged with dust or obstructed by
nearby objects.
•If low air flow continues, replace the air
filter.
•If the problem persists, unplug the projector
and contact Epson for help.
On Off Off Orange No air filter. Check to see if the air filter is
securely installed.
2

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite D6150 /
D6155W / D6250
3
Power light Lamp Temperature Filter light Status and solution
light light
Red Off Off Red Low air flow through the air filter.
•Make sure that the vents and air filter are
not clogged with dust or obstructed by
nearby objects.
•If low air flow continues, replace the air
filter.
•If the problem persists, unplug the projector
and contact Epson for help.
On Flashing Off Off Replace the lamp right away to avoid
orange damage. Do not continue using the projector.
Red Off Flashing red Off A fan or sensor has a problem. Turn the
projector off, unplug it, and contact Epson for
help.
Red or flashing Flashing Flashing red Off Internal projector error or air exhaust vent
red red error. Turn the projector off, unplug it, and
contact Epson for help.
Red Off Off Flashing The air flow sensor has a problem. Turn the
red projector off, unplug it, and contact Epson for
help.
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.