Ergotron AnthroBench 293 Series User manual

300-5002-00 rev. H • /
01– Leg Extension ............................Qty. 2.....................(see below)
24” Leg Extension (293xx) ................................... 625-5527-xx
36” Leg Extension (295xx) ...... ............................ 625-5528-xx
02– Base Tube Screws.................. Qty. 4..................325-5000-00
03– Bench Extension Caps .......... Qty. 2...................225-5376-xx
04– Keps Nuts (1/4-20) .................... Qty. 4..................325-5130-03
05– 1/2” Button Head Screw ..........Qty. 4..................325-5003-00
This instruction is for the 293xx and 295xx.
Before beginning assembly, review the parts listed below to verify that your shipment is complete. Items shown in
gray are not included with this accessory.
Review all instructions for your assembly before you start.
SAVE THESE INSTRUCTIONS!
Enclosed Parts List
AnthroBench Leg Extensions
Assembly Instructions
Fastener quantities listed are the minimum needed for
your assembly. Your shipment may contain a few extras.
A 5/32” Anthro Hex Driver, 1/4” Hex Key & 3-Way Wrench
(not included) will be needed for this assembly.
01
02
03
05
04
Built with Anthro-DNA™

300-5002-00 rev. H • /
Step 1 (requires a 1/4” Hex Key)
Remove the Leg Covers on both Leg Assemblies. Your Bench
Instructions illustrate more detail on this process if needed.
Next, remove the Leg Caps on both Leg Assemblies by
removing the two Socket Cap Screws on each Leg Cap.
Step 3 (requires a 3-Way Wrench)
Carefully place one Leg Extension onto a Bench Leg Assembly. Align
the two holes on both the Leg Extension and Bench Leg. Insert one
Button Head Screw per hole and capture it on the opposite side using
a Keps Nut. Repeat procedure for remaining Leg and Leg Extension,
then reinstall the Bench Leg Covers.
Step 2
Orient the Bench Extension Caps on each Leg so the
funnel shape is inserted down into the Leg.
Install two Base Tube Screws per Extension Cap into the Leg
Tubes. NOTE: The Base Tube Screws will be seated below the top
surface of the Extension Caps. It may be necessary to loosen the
preinstalled support screws on the Leg Extension to allow the
Base Tube Screws to insert freely.
Bench Leg Assembly shown with cover removed
Remove exist-
ing Leg Caps
Socket Caps Screws pre-installed onto the Legs
Funnel shape is inserted
into the Legs
Holes on
Bench Leg &
Leg Extension
Assembly
Cap Screw (not counted in the Parts List)
325-5136-00
Base Tube Screw
325-5000-00
Button Head Screw
325-5003-00
Keps Nut
325-5130-03
Congratulations!
Your assembly is complete.
Extension Cap
© 2018 Ergotron, Inc. All rights reserved.
All trademarks are the property of their respective companies.
Anthro is a registered trademark and brand of Ergotron Inc.
Anthro-DNA is a trademark of Ergotron Inc.
For local customer care phone numbers visit: http://contact.ergotron.com
For Service visit: www.ergotron.com
For Warranty visit: www.ergotron.com/warranty