ESI PL200 Operating and maintenance manual

INSTALLATION AND USE
PL200
KEYBOARD PLATFORM
PL200 Rev A 4/17
Model PL200

Snap
Palm Rests
into Holes
PL200 KEYBOARD PLATFORM
PLEASE REVIEW these instructions before beginning the installation. Check that
all parts needed were provided with your order. Contact your supplier if any
operates to your satisfaction.
PARTS PROVIDED
Keyboard Platform (1) Palm Rest (2)
Cap Nut (4) Lock Washer (4) Cord Clips (2)Flat Washer (4)
CAUTION:
Hand-tighten screws only. Do not use power tools.
1 Each for
Keying and Mousing
ADDITIONAL TOOLS REQUIRED
• Wrench or pliers
STEP 1: Attach Palm Rests
The mouse platform slides out to either side from under the
keyboard platform. The palm rests have ball snaps on
platforms.
• Determine user preference for left-side or
right-side mousing, and slide the mouse
platform out to that side.
• Snap the palm rests into the holes
on the keyboard and mouse
platforms.

PL200 KEYBOARD PLATFORM
STEP 2: Attach Keyboard Platform
• Fit the four screws protruding from the bottom of the keyboard platform into
the holes on the keyboard arm.
• Secure the keyboard platform using the at washer, lock washer, and cap
nut, as shown. Tighten the cap nut with a wrench or pliers.
STEP 3: Manage Cables
• Adhere cord clips to the underside of
the keyboard platform as needed to
organize the keyboard and mouse
cables.
TO OPERATE THE KEYBOARD ARM, follow the instructions on the keyboard arm
or the instructions included with the installation procedures for the product.
Cord Clip
Keyboard
Platform
Flat Washer
Lock Washer
Cap Nut
Mouse
Platform
Keyboard
Arm

800.833.3746esiergo.com
© 2017 ESI Ergonomic Solutions. All rights reserved. PL200 Rev A 4/17