ESI PLMAC Operating and maintenance manual

INSTALLATION AND USE
PLMAC
KEYBOARD PLATFORM
PLMAC Rev A 4/17
Model PLMAC

PLMAC KEYBOARD PLATFORM
PLEASE REVIEW these instructions before beginning the installation. Check that
all parts needed were provided with your order. Contact your supplier if any
parts are missing. Do not discard the packaging until satised that the product
operates to your satisfaction.
PARTS PROVIDED
Keyboard Platform (1) Palm Rest (2)
1 Each for
Keying and Mousing
Flathead Screw (4) Flange Nut (4) Cord Clips (2)Panhead Screw (4)
#8-32x1
/2#8x32 #8-32x5
/8
CAUTION:
Hand-tighten screws only. Do not use power tools.
TOOLS REQUIRED
• Phillips screwdriver
STEP 1: Attach Palm Rest
• Attach the palm rests to the keyboard platform.
Use the #8-32x5 /8panhead screws and a
Phillips screwdriver.
— Attach each palm rest with two
screws, as shown.
NOTE: The keyboard platform can be
switched from right-side mouse to left-
side mouse. First, before attaching the
palm rests, remove the mouse guards.
Turn the platform over and re-install the
mouse guards. Then install the palm rests.
Panhead
Screw
Mouse Guards

PLMAC KEYBOARD PLATFORM
STEP 2: Attach Keyboard Platform
• Attach the keyboard platform to the
keyboard arm and track assembly
using the four athead screws and
ange nuts.
— Be sure the ange on the nuts is
facing upward.
IMPORTANT: The ange nuts
must be fully tightened to
ensure the nuts are locked.
Use a Phillips screwdriver.
STEP 3: Manage Cables
• Adhere cord clips to the underside of
the keyboard platform as needed to
organize the keyboard and mouse
cables.
TO OPERATE THE KEYBOARD ARM, follow the instructions on the keyboard arm
or the instructions included with the installation procedures for the product.
Cord Clip
Flathead
Screw
Flange
Nut

800.833.3746esiergo.com
© 2017 ESI Ergonomic Solutions. All rights reserved. PLMAC Rev A 4/17